Backsprings in motion
-
What is that tool, a punch?
-
I think it's some kind of punch...for setting up explosives...not much "real world" use I assume, unless your into explosives.
-
I meant a nail punch.
You know, you hammer it into a piece of wood (or whatever surface) to make an indentation to help start up a screw/nail or to mark a spot. -
I suppose you could use it as an awl/screw starter. But the angle on the pointy end doesn't seem sharp enough to work very well.
Corrugated is right, SOG includes this "C-4 explosives" punch on their EOD model. It also has special crimper jaws. Per their webpage HERE "This makes it a breeze to crimp blasting caps and demolition cord with less hand pressure."
Probably not something most folks do every day....
-
the slot's could be made using a ED machine and it's a fantastic way of machining but slow .. then again it could easily manage 20 or 30 of them in one go .. that would be my guess. failing that a very very thin slotting cutter EDM seems most likely though.
-
@knife-man said:
the slot's could be made using a ED machine and it's a fantastic way of machining but slow .. then again it could easily manage 20 or 30 of them in one go .. that would be my guess. failing that a very very thin slotting cutter EDM seems most likely though.I was wondering about wire EDM too. It would leave no burrs or bulged metal along the edge of each slot, like any other cutting tool would do. But the process is so very slow....
-
if we could convince someone to bend one out and take a look at the surface finish on the inside I could tell .. EDM leave like a sandblasted finish. I doubt the inside of the slot's are polished in anyway after machining
-
@knife-man said:
if we could convince someone to bend one out and take a look at the surface finish on the inside I could tell .. EDM leave like a sandblasted finish. I doubt the inside of the slot's are polished in anyway after machiningYou mean the surface finish in <u>between</u> the fingers, right?
-
yeah ... I know what I mean even if no-one else does most of the time :-\
-
I'm holding onto the backspring fingers piece from my disassembled Spirit right now. (Don't ask!
) Anyhow, a piece of ordinary typing paper will barely fit between the fingers. Checked with a micrometer, the paper measures .0035" thick, or less than .1mm.I was told once that a wire EDM can only make cuts down to .2mm wide. How the heck does Vic cut those fingers?
edit: I forgot the decimal point in front of the 1mm and 2mm specs. Added 5-15-07.
-
Maybe they use water jets or something?
Tom
-
-
EDM can take .1mm cut's I think its's the smallest wire size available ATM.
and as .0035" is only just a smidgen under .1mm I would still suspect EDM If I had one I could check it with my shim's for a propper size check (presuming I could find them and that they arnt too rusty) .. Paper inst the best material for use as a Shim ::). But I cent afford to buy one.
-
@knife-man said:
EDM can take .1mm cut's I think its's the smallest wire size available ATM....Then you are probably correct about how the slits are cut.
Another good thing about cutting with a wire EDM (electrical discharge machine) is that it leaves no burrs or bulges in the metal, like a thin slitting saw or bandsaw would do.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login