First AA flashlight suggestions?
-
@Pablo O'Brien said:
A good set.

You seem to have most usage scenarios covered. :D
What about the Nitecore P12?
Do you have a whole collection of 18650 lights that you haven’t said anything about yet?
My list is rather shorter.

Thrunite Ti3 xp-g2 NW that I edc.
Manker E03H Nichia 219c that I am also edc’ing.
Cheap Chinese AA zoomie that I rarely use.It’s also a nice set

Yes I also have two 18650:
Nitecore P 12 (GT version)
Nitecore MH20 (GT version):D
-
P12 is great
get one -
@Blackbeard said:
P12 is greatIt’s one of my three all time favorites

-
The Manker E02 looks pretty well designed, with super nice heatsinking.

http://budgetlightforum.com/node/54776
I hope that the E03 is the same, just larger. After all, it shares the same bezel, lens, reflector, switch.
-
To give the OP some advice about the Fenix E12, though I’ve never seen or held one, the high mode is not quite high enough, and it’s missing a firefly/moonlight mode. :)
-
@Blackbeard said:
P12 is great
get oneBut I don’t feel ready for the power of a 18650 flashlight! :ahhh
-
@Pablo O'Brien said:
P12 is great
get oneBut I don’t feel ready for the power of a 18650 flashlight! :ahhh
You are ready ;)
-
they had P12 deal back around thanksgiving, bit more money now, but you can get Covoy S2+ for under $10 and dip your foot in the water.
-
what do you mean by not ready?
-
Erm... I don’t need one yet?

Still in the “ooh cool, I have a new torch!” period with my E03H :D -
Best advice is RUN :ahhh, while you still have your whole life ahead of you
flashlight addiction is smurfing hard to escape -
Don’t worry, if past experience is anything to go by, I’ll get another light in 2020.

-
Oh, you’re soo ready for 18650 Pabs...

Forgot where I read it, but for survival situations, ideally should have at least an 18650 light and an AA/14500 light... 18650’s gives you more light... and should you run low or run out of juice, there’s always the AA/14500 as backup. Especially AA’s being the more common sized ones (at least in my part of the woods)...
AAA’s are more pocket friendly for urban EDC...

Sent from my iPhone using Tapatalk
-
We’ll see.
:D -
The Armytek Wizard Pro V3 USB is also good if you want another angled light [emoji23]
Sent from my iPhone using Tapatalk
-
Looked it up... what an awesome monstrosity! :D
-
@jaya_man said:
Oh, you’re soo ready for 18650 Pabs...
Forgot where I read it, but for survival situations, ideally should have at least an 18650 light and an AA/14500 light... 18650’s gives you more light... and should you run low or run out of juice, there’s always the AA/14500 as backup. Especially AA’s being the more common sized ones (at least in my part of the woods)...
AAA’s are more pocket friendly for urban EDC...

Sent from my iPhone using Tapatalk
Cool pics

-
Oh, you’re soo ready for 18650 Pabs...

Forgot where I read it, but for survival situations, ideally should have at least an 18650 light and an AA/14500 light... 18650’s gives you more light... and should you run low or run out of juice, there’s always the AA/14500 as backup. Especially AA’s being the more common sized ones (at least in my part of the woods)...
AAA’s are more pocket friendly for urban EDC...

Sent from my iPhone using Tapatalk
Cool pics

Thanks CeHo

-
I did some rough maths on my calculator.
The E03H has 21 possible moonlight modes, which can be programmed with "engineering mode".
Assuming that the highest (21st) moonlight setting is 1.5 lumens, and that each setting is 75% brighter than the previous one, then the lowest should be about 0.004 lumens. :ahhh
Given the uncertainty involved, give or take a few thousandths of a lumen. ::)
All I can tell you with certainty is on the lowest setting, I can just about tell that the LED is on by looking at it, that it is definitely on, and that it provides no noticeable illumination at awl, even on super close-up objects, and that the 0.02 lumen mode on my Ti3 (value measured by selfbuilt) is a blazing amount of light by comparison. -
@Pablo O'Brien said:
I did some rough maths on my calculator.
The E03H has 21 possible moonlight modes, which can be programmed with "engineering mode".
Assuming that the highest (21st) moonlight setting is 1.5 lumens, and that each setting is 75% brighter than the previous one, then the lowest should be about 0.004 lumens. :ahhh
Given the uncertainty involved, give or take a few thousandths of a lumen. ::)
All I can tell you with certainty is on the lowest setting, I can just about tell that the LED is on by looking at it, that it is definitely on, and that it provides no noticeable illumination at awl, even on super close-up objects, and that the 0.02 lumen mode on my Ti3 (value measured by selfbuilt) is a blazing amount of light by comparison.Have you tried any of those Low Lows at night with dark adjusted eyes yet though?
It can be surprising how useful they can be once you are used to the dark!
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login