KutMaster Multi-tools.
-
No and the guy stopped responding to my emails. Ah well.
It is made in China, but apart from the cutters not working its a great tool. I’ve given up on cutters that work on these tools. They didn’t work on that bent up multimaster either. Coast got wire cutters right with their 2 piece pliers, but the wrench head and variants has a t handle bit driver which is absolutely amazing.
So what I’m doing is sliding an ES4 into the little pouch for the sockets in the wrench head sheath. That will handle any wire cutting and stripping duties that the kutmaster can’t handle.
Also, for my uses I’ve removed the serrated blade from the Winchester tool and added the feeler gauge and awl from the wrench head. Actually I also swapped in the main blade and combo file/gasket scraper from the wrench head too. The scraper is useful to me, even though the Winchester has a better file.
Because the Winchester is wider, I was able to remove the very thick serrated blade and swap in the very thin feeler gauge and medium width awl just by leaving out a couple washers. So I have one extra tool in my modded Winchester.
I’ve stuck a flashlight in the case, an extra row of Allen bits, and the ES4. It now lives under the seat of my motorcycle along with a set of spare brake and clutch levers, a cable lock, and a bungee net.
Charles.
Charles.
-
I tried the cutters on both of my MMs. I started with bamboo skewers and made 20 cuts on each tool. Then checked the cutters with 18-2 stranded wire. The BN version cut the wire before the skewer cuts, but had trouble afterwards. A little tightening of the pivot screw solved the problem and it now cuts fine. The NN version cut the wire before and after the skewer cuts, without tightening the pivot.
The bent handles may cause the cutters to not bypass properly. I would try emailing the guy everyday until he resonds. He promised a functioning tool and shoudl deliver. IMO of course.
As far as the Winchester. Glad you found a setup that works for you! The ES4 is fantastic.

-
Interesting tool
and cool that they sent you a new one from the company
to bad that the QC isn't there though 
-
I think Charles may have received a factory second MultiMaster. :-\
Marks on plier head from movement and a bent handle. Sounds like a classic factory second. :ahhh
-
Bringing up this thread again. Has anyone else seen the Garrity hammer tool? It appears to have a full tool load and door that matches the Kutmaster Multimaster. There are several of these on eBay right now around the $20 mark.
Charles.
.jpg)
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login