One week with the Wave Plus
-
I just checked my Wave+ and
I have exactly the same as you Pacu
-
LM switched from fine teeth to coarse teeth a few years ago. Did it to the 300 and Surge too.

It isn't a Wave+ only thing. :)
-
-
Its because that's the new plier design.
The Wave in the pic is stamped 03-23-18

-
Is there any benefit for why they changed the pliers design

-
@CallsignBadger said:
Its because that's the new plier design.The Wave in the pic is stamped 03-23-18
I see,

my ST300 is 0314 and my Wave 0612
-
Weird

-
some backlight
-
I don’t get it ???
-
it grabs at the very tip well but I can slide a sheet of paper between the main teeth easily
-
might be because bigger, thicker teeth don't get as worn out and damaged over years of grabbing, twisting and holding stuff?

-

My Vic Spirit S has got damaged teeth at the front caused by the previous owner. These are very fine too and therefore less durable.
And face it, how many times do you use pliers for that ultra fine pulling work? You'd need tweezers for that

I don't think this is a bad move from LM... at all!
And that coming from a Vic fan... ;) -
Makes sense

-
My Vic Spirit S has got damaged teeth at the front caused by the previous owner. These are very fine too and therefore less durable.
And face it, how many times do you use pliers for that ultra fine pulling work? You'd need tweezers for that

I don't think this is a bad move from LM... at all!
I couldn't agree more!

I buy a lot of "lightly used" MTs and the biggest issue I have is the plier teeth, as those are arduous at best to repair. Fine teeth take hours and hours of using a mini-file to reshape. The newer coarse teeth, while also much harder to damage, take just a half hour or so with a mini-triangular file . :)
Only down side to coarse plier teeth is tool marks if you slip thr grip on something :ahhh
-
Yeah, easier to get tool marks, or teeth marks, with a bit of slippage, but in general I prefer an aggressive tooth. If I need to be more gentle, I'll wrap a bit of duct tape around the teeth to protect the material I'm working with.
-
But then if you don’t want teeth marks
You shouldn’t use pliers
Only the correct tool for the job
-
I think that new desing is bit bettwr when need hold nuts and bolts or something else with same kinda desing.
Only Tools Matters
-
I've been loving the new design so far

The tips are also very precise, and they do seem infinitely more durable.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login




