Livarno, Romisen, C8, Small Sun cheap HID torches
-
.
-
Nice one!

-
It is.
It is very impressive when used in open spaces, like the countryside ,where it illuminates a large area reaching way ahead.
You can then see the actual power it has, compared to other powerful lights.
Ever since Enci disappeared and Gareth semi-disappeared this thread get very few replies :D
-
Do you have some outside photos?
-
not with the new lights - I did some throw tests a few years ago
I need to do some again
-
Following a request, here are some beam comparison shots. These are all powerful torches and a comparison shot with the car headlights, on high beam is included, to put the torch beams into perspective.
I am including the claimed lumens, though some may be a bit exaggerated. The Trustfire was on 2 batteries, but it can also be run on 3, for a slight increase in brightness. -
.
-
Great photos dks!

That BLF is one powerful flashlight...
-
all the lights used are powerful but the Q8 is on a different level.
the car's headlights are pretty decent too - never felt that they were weak when driving, for comparisonthe lights were at about 1.5m from the ground.
-
Went for the cheapest C8
MECO C8
The emitter is supposedly a T6 but not a Cree one. Still bright enough.
18650I took some comparison shots with the Romisen RC-T601
Meco on the left in the beam photographThe Meco is less solid, slightly less bright but has more throw. For under 6 Euro it is worth it. Good threads, 5 modes, bad PWM.



-
Utorch V8 XPL Available with stepless dimming or separate modes (cheaper)
Compared with the BLF A6
Impressive matt finish, nice squared threads - It can easily carry a Fenix, Olight etc. sticker.
Appears only slightly dimmer than the A6 Avery good buy, at half the money, under 8 Euro.
PWM is bad, the A6 one is way better.
OP reflector, slightly smaller pits than the A6.Utorch on the left in the beam photograph




-
I got a new Nitecore TIP SE to replace an older (2015) TIP
The original one still works fine but one rubber button was torn, so I put a rubber tyre patch on top of it. Still, since it is no longer weatherproof I decided to get a new one to replace it.
Issues with the old one? The torn button and the very poor resistance to friction of the anodisation. It used to be blue but the colour has gone. In comparison, an old, used LM squirt, carried on the same key-chain for even longer still looks pretty good. I have included a photograph with a Tank light, carried for way more years, for comparison.
Basically, the SE has twice as many LEDs and of a different brandthan the old one, twice as many Lumens on Turbo and a USB C charging port instead of the USB Micro. The low, medium, high modes are about the same. So is the size and overall functions.
If you do not need the higher Turbo mofde then there is no reason to upgrade.
The original one cost me 18 USD and the new one 29, shipped to me.
The new one has a slightly wider beam, though they are both fine.
-
I think a problem with the coating may be that it's a flatter profile light, so more of the surface is exposed to friction at any given time. The tank light example you gave along with it is entirely bare of ano at the points of contact, whereas the TIP still has a bit of a 'hue' to it. Looking forward to seeing how it holds up overall, it's an interesting light that's for sure!
-
The LM squirt was on the same keychain and that also has flat sides. It has minimal damage to its coating.
-
@dks said:
The LM squirt was on the same keychain and that also has flat sides. It has minimal damage to its coating.That probably says something about the Leatherman ano rather than the Nitecore's...
I've never known ano to hold up to prolonged keychain use (over years) without substantial loss (usually 100%) at the points of contact.
It'd be a better metric if you could gauge how quickly it lost the ano, rather than the end state after years of key carry.
-
The anodized finish on the TIP always struck me as being very thin as well. Good light though and I still like my CRI. As you say; I'm not certain I'm going to rush out and replace it with the new version just yet. Cheers for the pics and thoughts mate.

-
Jetbeam Mini One SE
This is another small keychain light, available with a metal or plastic opaque body and metal head (SS). It is also available from Nitecore, with lower power output - Nitecore Tiki. (Nitecore and Jetbeam are related, from what I know, part of Sysmax)
Having an internal battery and an on/off button helps it to be quite small, comparable to an AA battery.
Specifications can be found here : http://www.jetbeamlight.com/products_show318.html
The turbo output is 500LM (30s) and it has regular modes from 200 to 1LM (could have been lower). Nice white beam.
I have included some comparison photographs with the Tank007E09. The beam comparisons are done with both on High, Tank at 120 and Mini at 200LM. The Mini has a hotter central spot and more spread.
The light brings many functions of cheaper. fun, lights to a product made by a real company.
It has, in addition to the standard beam, 4 extra lights on its side.
3 are powerful (150LM) coloured LEDs (R, G, B) that can flash in sequence. This function is useful when walking (the reason I got this light) or for parties....
You can also have just the red LED flashing, like a beacon, just the red or blue on etc.1 is a UV light, reasonably bright that can be used for various tasks, like checking the cleanliness of toilets, checking money and so on.
You access the main modes by number of clicks and then change through the variants with longer clicks. Easy and simple.
Why did I get the plastic bodied one instead of the metal bodied one?
The plastic one luminesces in the dark (like watch dials). The metal one does not.
When you use the coloured LEDs in the plastic one, you get light form all around the body of the light, making you more visible. With the metal one, if you accidentally cover the LEDs with your finger or body then you will not get any light coming out.
The plastic one is cheaper - about 18USD should get you one to Europe, whereas the metal one is a few USDs more, usually
However, the metal one looks fancier/classier and should be tougher.
-
UV light
-
You miss me here? ;)
Some interesting lights, I like that BLF one with the 4 parallel cell setup, but I'd prefer it to be a flood light for photographing large dark spaces.
And the last keychain light is cute. It wouldn't push out my old trusty ITP A3 SS off of my keychain but it would be a nice toy to play with ;)
Also nice to see you still loving the Tank, I'm guessing it's your favourite keychain light still, right?
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login
