What Did You Use Your Multitool For Today?
-
I was tearing out a ceiling and putting in a large patch the other day, and there was a vent fan/light combo in the middle of it(bathroom). I had to use my Rebar's flat head driver to pry the fan shroud into the hole into the new piece I had cut. That Rebar saw a lot of use that day. I also had to use the saw to trim some sheetrock to fit, and realized that there really isn't a substitute for a good sharp keyhole saw...
-
Skeletool to put up curtain hangers after painting the bedroom [emoji106]

Sent fra min FRD-L09 via Tapatalk
-
Gerber Suspension to free some new drill bits from the plastic of doom >:D

-
Have been busy a whike, but had Some time for my ham radio hobby yesterday, and used my surge a lot while adjusting an Antenna.




-
Very short description:
Ham radio or Amateur Radio is mainly making radio contacts all over the world. Can be done in voice, morse (cw) or all kind if digital modes.
Many apspects involved, i especially like making and tuning Antenna systems, and use them to get as long distance contacts as possible. For example, from the netherlands where i live, to a friend in Brazil. (Making use of shortwave bands and radios)
It is like make phone calls, but without the lines between.
-
That is pretty cool! I just wonder, do you have to bounce off the radio signals over a relay? Because earth‘s curvature should prevent a direct connection between Netherlands and Brazil, right?

-
No, for shortwave, that is not done by a relay, it is a direct contact. The Antenna radiation angle will send the signal into the ionosphere, where it will bounce back down again.
For local contacts on 144-146mhz there are many relays here, but that is for short distance like 50km or so
-
Very interesting, thanks for providing some details

-
I used the Centerdrive Today to remove the intake wall plate from a Central Vac system in a huge house.
Then I grabbed a non-conductive fish tape and reamed the pipe in the wall for a few hours attempting to dislodge a blockage of some kind.
I closed the connections with the pliers to make the vac turn on with no hose attached to test the reaming?
I then took a Shop Vac to the thing and alternated between sucking with the shop vac and blowing with the central vac trying to move the blockage in either direction even a little bit!
After about 45 minutes of this I was able to grab and extract some kind of furry beast with the CD Pliers thus restoring the inlet to working!!!
I am not a Vac technician.

-
Great work ezdog

-
Great work ezdog

It was an adventure for sure!
Also required much creative language but no real challenge for me there[emoji106]Sent from my iPhone,dont expect too much[emoji85]
Sounds a adventure

I use creative language quite often as well :DIn the interest of transparency the cleaning people spoke no English anyway so it is always an adventure there anyway!
And I no habla so........
Sent from my iPhone,dont expect too much[emoji85]
-
Used the PST II to replace a fire alarm


-
Nice work guys!

-
Used the Supertool 300 and the squirt to help make wire bails for my opinels.
Recently got in some suspension clips and wanted to try them out on my opinels. Used the awl to make a pilot hole for the drill. Used both plier heads and cutters for forming the bails.


Sent from my SM-G920V using Tapatalk
-
Nice work Anka

Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login

