What did you use your Sak on today?
-
Great work BP

Worth trying for a new MT good luck
-
Good usage BP.
anyone who does not know what an awl is good for does not do DIY with a SAK. 
-
I used my Outrider's cap lifter to pry the old 120V power outlet cover off the center console of the Ford Escape, and replace it with a new one; which snapped right on. Why should I have to go to the dealer for such a trivial task? The only thing I did was cause a few small tool marks on the plastic of the console; but the new cover hid most of those.
-
Good work cody

-
@cody6268 said:
I used my Outrider's cap lifter to pry the old 120V power outlet cover off the center console of the Ford Escape, and replace it with a new one; which snapped right on. Why should I have to go to the dealer for such a trivial task? The only thing I did was cause a few small tool marks on the plastic of the console; but the new cover hid most of those.Good usage.

...did not invalidate your warranty?

-
@Max Stone said:
Good usage.
...did not invalidate your warranty?

Being as it was just a small trim piece, I would assume it would not. And I don't think anyone will notice what I did. There was nothing electrical even connected to it--basically it was the automotive equivalent of a switch plate cover. But I did delay putting it in for 3 months, in part because of that. As, I figured if they messed up, it would be on them to fix their mistake. If I goofed up, it was all on me. But I was waiting on my folks to get their hair cut, and had absolutely nothing better to do, so I just put the part on while I was waiting. And the Ford dealer the car came from is a half-hour away, wasted trip for just a small trim piece that isn't really a problem other than looking bad broken.
-
As of this morning, I've already used my SwissChamp for the following:
Worked on some wall trim that wasn't quite cut to fit near a drawer. It had to be cut out to allow the kitchen cabinet drawer drawer to clear it, but not enough. I've been cutting a lot of it away, but used the chisel this time. I was surprised at how well it worked, especially on a 20 year old secondhand SwissChamp.
Used the saw to cut some notches into the deflector of the riding lawnmower deck. My grandfather likes to keep it up; and uses two rubber tie-downs to do so, but it slips off. I'd put two in the left side last season, but needed to put some on the right today.
Cut weed eater string with the scissors.
Sharpened the ends of the line with the pen blade. The head I put on my FS38 is a quick-load one, and according to the service rep, sharpening the ends makes them slot inside to lock into place better before spooling it inside the weed eater. -
Great uses cody

-
@cody6268 said:
As of this morning, I've already used my SwissChamp for the following:Worked on some wall trim that wasn't quite cut to fit near a drawer. It had to be cut out to allow the kitchen cabinet drawer drawer to clear it, but not enough. I've been cutting a lot of it away, but used the chisel this time. I was surprised at how well it worked, especially on a 20 year old secondhand SwissChamp.
Used the saw to cut some notches into the deflector of the riding lawnmower deck. My grandfather likes to keep it up; and uses two rubber tie-downs to do so, but it slips off. I'd put two in the left side last season, but needed to put some on the right today.
Cut weed eater string with the scissors.
Sharpened the ends of the line with the pen blade. The head I put on my FS38 is a quick-load one, and according to the service rep, sharpening the ends makes them slot inside to lock into place better before spooling it inside the weed eater.That SwissChamp is getting a workout today!

-
I put together an Ikea cabinet with my Pioneer X. And our swiss, erm army dog(?) also tried to help.

-
Great use Petteri and gorgeous looking dog

-
Used the scissors on the PioneerX to open a package



-
Visiting a relative in the hospital, I had a minor problem. The piece that clamps the ends together on my Lock Laces I have on my sneakers had come loose (again). That would have been no match for the SwissChamp, which due to the hospital's "No Weapons" policy, I'd left in the car. So, out came the backup checkbook-bound SwissCard (which is bladeless because I took the blade out). I snipped the laces to equal lengths at the ends with the scissors, (eventually, after 5 minutes) had used the nail file to pry the clamp apart, I stuck the laces inside it, then snapped it back together.
The SwissCard works ,but I'd much prefer my Style PS (which I misplaced) for a bladeless carry when there are no searches or metal detectors.
-
@cody6268 said:
Great use! And that's why nail guns freak me out, even though I use them all the time. We've been using finish nailers modelling house, and I've handled that thing with more caution than a loaded firearm.On another note, I'm surprised they don't make a big fuss over MTs at the hospital you work at. The two main hospitals here have signs everywhere against carrying a pocketknife, even at the outpatient/doctor's offices run by them. One clinic (which my grandmother's doctor is in) is extra sneaky in that they put the sign "NO WEAPONS OF ANY KIND" inside the main entrance. I've got to the point that if I'm belt carrying, and waiting on my folks at that doctor, and i have to use the restroom, I just go to the fast food restaurant a mile down the road. At least my doctor, who runs his own office, really doesn't care; whether it be some guy concealed carrying; or me unloading my EDC when I get weighed.
Thanks for all of your replies people and more so from you cody6268.
I have been carrying a SAK as my EDC in our Emergency Department for 30 years now and fortunately I have never been given any real grief by those in charge, so I have been lucky I guess.
My first EDC was a Victorinox Scientist which I bought in 1990 and I carried that till the year 2000 until I lost it courtesy of a hole in my pocket and I was even more annoyed later on when I found out that it was a very collectable SAK. That started off my interest in swiss army knives and I have managed to obtain several of them over the last 15 years or so.
I really hate it when I lose pocket knives and that started in the early 1970's when as a young boy and I managed to lose 3 pocket knives in the space of 3 years, all on my birthdays when I received them as presents. They were nothing special, just Richard's brand pocket knives that were made in the UK and were a cheap mass produced knife,but for me at the time they were the best gift you could ever receive as a boy because you felt almost like a adult to have the responsibility of carrying a pocket knife.
The Scientist was a favourite of mine, though I prefer the Victorinox Compact I replaced it with as my EDC today, because of those very useful scissors. I do have a mint Victorinox Yeoman in it's box with the original papers and that has the best of both worlds in regards to both the Scientist and the Compact's tools, but my Yeoman is too rare and valuable to be used as a EDC and so it is a shelf queen, as I would hate to damage it through every day wear and tear or even lose it.
In regards to my Victorinox Spirit XC, I find it a bit too heavy to carry in it's leather case on my belt so I keep it in my work locker in my backpack and I very rarely use it as I did when that nurse requested it for a doctor to remove that nail from the hand of a patient.
The other problem is that it has that locking blade and other tools (it's a serrated "butter knife", but..) and here in Melbourne Victoria that is a big no, no in regards to the law. The irony is that I mostly use that blade for cutting a crusty bread roll or steak at work and little else - it's brilliant as a dinner knife! LOL.
Its funny also that we have police officers and even the odd detective in our Emergency Department on most days, either escorting "psych patients" and car accident patients in or guarding a someone that is under arrest or when we have a code black (a violent internal situation) in progress. Thankfully I have never been pulled up by the cops over my SAK and that might be because I keep it on me discretely and securely attached to a leather lanyard on my belt which disappears deep into my pocket.I also have a photo to show everyone of my small collection of Swiss Army Knives and those red alox "old cross" ones are my favourites.
-
Some great info there, thanks OMS.

I’ve thought before about deconstructing an old Swiss Champ and using the Phillips/magnifier layer to make a Yeoman from a Compact. I believe this is a common mod.
-
Used the Huntsman to open a package




-
Nice badge WS.

-
Thanks Max

Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login
