Lets get posting! v2
-
But I did come up with some ideas for the ramp
So that it will sit flush with the platform when connected
-
Just need to try some things out and see if it will work

-
Working at my mums at the moment
But should be finished in about a hour
And then I can get started with work at home
-
Parts arrived to fix my drone today
And it’s as good as new again....WOOHOO!!!
No more zip ties to hold the camera mounting bracket together
Sent from my iPhone using Tapatalk
-
Great news MMR

Now no more crashing
-
I just got back from my mums house

Now it’s time for a quick coffee and then
I am going to try out some ideas for the ramp
-
Tried a few ideas for the ramp but I wouldn’t
have enough plywood to make what I wanted
So it’s back to the drawing board for me >:( -
Didn’t get much done on the ramp today

But I know now what I am going to make
The pics are only for the height and angle of the ramp
The ramp is going to be a bit shorter and a bit wider

-
I have got a sheet of plywood ready measured up
To be cut but it’s just too hot outside at the moment
If I use the circular saw now all the wood dust
will be stuck to my body as I am sweating buckets >:( -
I will have to wait to finish the ramp until the flooring has been done
So that I can get the wood cut on both sides to the correct angles :ahhh -
Unfortunately the spray adhesive didn’t get delivered today
So the earliest I will get it now is on Tuesday if lucky -
And hopefully I won’t have to wait to long
for the aluminium angle to get delivered
-
Can’t wait to get the flooring done so I can get the
wheel chock fitted and try to adjust it to the bike wheel
As long as the ramp is finished otherwise
I still won’t be able to put the bike on the platform :ahhh -
Going to the supermarket in a bit to get some food for the weekend :D
-
Just waiting for my daughter to get back home and then we can go
I hope she doesn’t take too long as I am starting
to get hungry now it’s cooled down outside finally :ahhh -
I spent some time working on the Jeep this morning. I had to change the left side rear axle bearing and seal as it leaked during extended driving. I also finished plumbing in the second compressor for my OBA setup. Now I'm sitting back enjoying a beer, and trying not to fall asleep!

-
A beer would be nice right now

-
Especially with the heat we are having today
The thermometer is reading 34°C at the moment :ahhh -
I was only outside cutting some plywood sheet
with the circular saw for no more than ten minutes
And I am soaking wet with sweat ??? -
So now I am indoors under the ceiling fan to cool down
Before I get anymore work done outside >:(
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login
