Scalpel Holders for Wave/Charge
-
Not bad I like the weight of the Wave when cutting

Not sure what it will be like using it for delicate work
-
I have a Swann Morton scalpel holder, I'm sure a multitool will handle different. :o
-
I would think a proper handle will work better

-
I am using these blades that are
more like a knife than a scalpel blade

-
They are excellent blades

-
Got mine today!
Good grief, it took over 2 hours to get it to fit properly in my Charge Tti, lock up, as well as accept a blade. Sooo, if you aren't into modifying things to make them work, don't get one of these. I love doing stuff like that and am very good at it (I've been modifying EDC/non-EDC stuff for over 40 years) but really shouldn't have to spend over 2 hours just to make something brand new work properly.
It works perfectly now.


-
Never seen the blades around here actually
-
I thought it was just my scalpel
holder that had those problems
I am glad to hear that you got it to
work properly in the end srvctec
-
I still havnt ordered mine yet, as I’m deciding on which other bits to get too!

For what you get, it’s well worth it in my opinion. Even if it takes a bit of tinkering to fit, you get a great mod at the end of it.

-
I rather have to do some work on it then getting the
scalpel holder and the fitting and the blade are too loose
-
@RicHT said:
I still havnt ordered mine yet, as I’m deciding on which other bits to get too!
For what you get, it’s well worth it in my opinion. Even if it takes a bit of tinkering to fit, you get a great mod at the end of it.

@Wspeed said:
I rather have to do some work on it then getting the
scalpel holder and the fitting and the blade are too loose
I agree in the end it's worth it. It might also be that at least on the Charge Tti, the scalpel holder is too thick by quite a bit. I had to remove material from each side of the pivot with my belt sander, including the built in "washer" as well as grind at a slight angle to correct it to close properly. Then I had the same issue as Wspeed but worse. I had to remove material from each side of the groves with a .5mm (maybe smaller) diamond bit in my Dremel to get the blade to even go on and even more to get it to seat properly. Once that was all done, I worked on the lock seat and removed about 1mm at just the perfect angle. Then I used my Dremel to deepen the grooves on the thumb stud since it was so darned slippery. The last thing I did was to remove about 2/3 of the raised button that holds the tail of the blade up since it raised it too much, making it seem like the blade might slip off.
Having said all that, it works perfectly now with the stock bronze (or copper?) washer so it opens easily, lock-up is perfect and tight and it closes perfectly.
Now I just need to figure out how to carry an extra blade or two. I think I'll make a Kydex (actually Boltaron) holder and attach it to my sheath.
-
You definitely had a lot of work to do
I only had to work on the grooves for the blade
And used a thin cutting disc on my Dremel on a low
speed to remove some material from the grooves
Removing a bit of metal from the locking
seat only took a few strokes with a file
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login