Easy Swiss Champ blade swap
-
After cutting, I polish the end which also takes off the sharp edge.
I then put the collar back over the pin and use the anvil end of my vice to peen the pin into a rivet head shape. It’s important to peen enough to get a proper seat inside the collar, but also to close the layers tightly enough to not have wobble on the tools. To check, it helps to turn the SAK over and tap the opposite end of the pin when on the vice with the jaws open. Then turn back and continue to peen the top rivet on the anvil. It’s possible to have the fit too tight, and then the tools bind and won’t snap. But it’s generally a case of too much tool wiggle. So take time to check the peening is the correct tightness by testing the tools for wiggle.




-
I polished up the rivet when done, and then gave the SAK a good wash, opening and closing all the tools to get it clean.
After a good rinse and dry, I snapped the scales back on. Oiled and all done!




-
Beautifully done 'how to' there Max

Lovely pics. -
Thanks magentus

-
Awesome job, Max.
Very good job.
I picked up a handyman special of 58mm's, that included a MiniChamp and 2 additional classics. Looked like someone had taken a grinder to the scissors and main blade on the MiniChamp, so I did basically the same as you.
Salvaged the scissors from 1 classic and the blade from the other. Drove the old pin out with the new, replacing the tools as I went along.
Funny, how every source said that I had to totally disassemble the knife in order to replace the tools...
This was my first, and only, so far, attempt at repair of a Victorinox.I was pleased with the outcome.
-
Great job Max... well done

I didn't try the push-through method yet.
Will keep it in mind for sure after seeing this :D -
Thanks PitCarverb and Matt.

If you measure the pin lengths it should be possible to replace any tool down the stack. I used the same method last year to replace the CS of a Ranger with a Phillips to make a Master Craftsman. So this is a viable method for both the center and outer pivots.

-
Amazingly instructional.
-
Thanks NetsNJ

-
Great work, Max! Great write-up as well!

-
Another awesome how-to! Thanks for taking the time to post this, Max. I really enjoyed reading it.
Myron
-
Thanks Sir Vic, Myron.

-
Excellent work Max and great write up and pics

-
Thank you Wim.

Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login