New guy with a bit extender problem/question...
-
Bought mine the other day. As soon as I put it in it got stuck immediately. Found this forum and saw that everyone else has had the same exact issue.
After reading through and hearing how much people were struggling to pry it out. Now this of course will only work if you have a brazing torch. Took my torch heated up the end till it was bright red and was able to remove it easily. Pretty insane that this is what Hass to be done to do it without any swearing or too much headache but going to remove the ring that binds the bit inside and put a magnet in the bottom which one of the other uses recommended. -
Welcome to
tgasbarro
Hope that the fix works out for you 
-
BOTH of the two extenders I have had lock in bits..ESPECIALLY normal hex bits. I may just add a magnet like others have done..
-
A less ostentatious way is: using a regular hex bit (Preferably a long one) placed in a vise with point down, insert extender; use a medium/large flat blade screwdriver to pry out extender, repeat until split ring stretches and holds bits with enough pressure and/or to your liking; it worked for me (repeated cycle X3 times), and does not affect the tool's tempering.

-
@Juan el Boricua said:
A less ostentatious way is: using a regular hex bit (Preferably a long one) placed in a vise with point down, insert extender; use a medium/large flat blade screwdriver to pry out extender, repeat until split ring stretches and holds bits with enough pressure and/or to your liking; it worked for me (repeated cycle X3 times), and does not affect the tool's tempering.
This is awesome ! why is there no way to save specific posts like this for later reference :'(
-
@Happy Gilmore said:
This is awesome ! why is there no way to save specific posts like this for later reference :'(Bookmark top of page works
-
@McStitchy said:
I've had the exact same problem on the first extender I've bought some years ago for my Wave.
I took the ring out, cut off the overlap part and put it back. No problems since
Not sure of anybody understood what I wrote to this a while ago. In my case the problem happened only at the party where the ring overlaps (has two layers). If I insert the bit in a way that it is held where the ring doesn't overlap then all was fine.
I did take the ring out and shortened/cut off the overlap part anyways.Regarding the magnet idea I think it will not work well with LM flat bits as they have a driver profile on both ends, so there is less material to be attracted by the magnet.
-
This thread really helped me. I took the wooden jaws off my bench vise and removed the stuck leatherman bit. Then, I removed the retention ring (using a tiny flathead screwdriver) and cut off the overlapping piece with am the wire cutter on the inside of the pliers. I put the ring back in (now no overlap) and it works perfectly. The bits stay in even when you shake the extender hard, and they are easy to remove with fingers. I would have never thought to do all of this if it weren’t for you folks. Thanks so much!!!!
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login




