Skary Skeletool October Challenge?
-
The Edge on the scallops of the serrated sectIon must be a lot weeker than the plain edge due to having less than half the inclusive angle due to being ground shallower and only on one side.
They are normally protected from hard surfaces (when cutting on a board) by the points.
-
Day 7 of 30
Today Skeletool just hanged with me, played few times with it but no particular good use today.

Only Tools Matters
-
-
I found the hammer adapters on line and they are around $30.00 U.S. so too pricey for me, but I still think they are a great idea.
-
I would try to grab the flats because there is more surface contact and less chance to slip.
-
I use a pocket diamond coated sharpening rod to smooth out serrations but I use a very light touch so as not to gouge or cut too deep.
-
-
Day 07:
Pulled a big carrot out of the garden to have for lunch. Skele trimmed the tops off and cleaned up the ancillary rootlets.....

Then....a knock at the door......
Like a bad crime scene photo:

-
That carrot looks like a monster.
I’m guessing the spyderco is your new endura.
-
Edit: found it when I went to the website and not tapatalk.
Nice Endura, and
the zome versions Spyderco has look awesome

-
Hello Day 8
So I wanted to change the battery in the kitchen clock and of course I dropped it and broke the case that holds the battery in place.
I thought some duct tape would hold the battery in place firmly so would make proper contact and we would know what time it is.
That did not work so out with some small cable ties and she is all zipped up tight and working properly now.
Skele to cut off the excess bits of tie.
.jpg)
-
Nice repair!
-
Lots of great day 6 and day 7 pics, everyone

-
Day 7 of 30
Used the Skeley to sharpen a pencil again and used the cutters on the pliers to cut a plastic brick band


-
Lookin' good, Poncho!

-
Day 7
Not a lot doing today.

-
Day 7
In addition to the usual package opening and snack cutting, I used the Skeletool with an Allen bit from the LM bit kit to do some adjustments to my water rower.

This was my first time using a LM flat Allen bit. It did work, but I noticed that because of the tip being modified to make it flat, it doesn’t grip as nicely as a hex bit or Allen wrench. -
@Alan K. said:
- I found the hammer adapters on line and they are around $30.00 U.S. so too pricey for me, but I still think they are a great idea.
I was considering doing a giveaway as part of this challenge and so now I have decided. It will be winner’s choice of one of the hammer or wedge adapters for the Skeletool.
To be entered in the GAW, post a picture of the Skeletool with a Halloween or Fall decoration saying that it is your GAW pic. I will randomly select the winner on October 31st - Halloween.
-
Very Nice, Sos24!

-
:o must make Fall pics :ahhh :ahhh :ahhh Very generous, Sos

And thanks Nix

-
Day 8:
Opening parts


Sent fra min FRD-L09 via Tapatalk
-
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login

