What did you use your Leatherman for today?
-
Thanks for reposting the pic

-
@Juan el Boricua said:
Well, the Wave got KP duties today: opened the diced tomatoes paste; cut the onion; opened the pasta bag; opened the wine for the sauce; peeled and cut the "chistorra" sausages.
A job well done. Great Sunday MT.o'er's and, stay safe! :tu
A cork screw :ahhh

-
@DavisNikolov said:
Excuse the double post but I realized the photo was visible only to me and the edit time on the previous one has expired. Here it is
Excellent use of the pliers

-
Today I've used the OG Wave to unwrap a movie I always wanted to watch :P

-
Used the Rebar to tighten the bolts on a LED panel I use to light the path around the house. Since those were loose it didn't want to stay in the correct angle so it didn't illuminate the whole path. To be honest, if I didn't have a MT in my pocket, I was just going to leave it for... sometime later


-
@DavisNikolov said:
Used the Rebar to tighten the bolts on a LED panel I use to light the path around the house. Since those were loose it didn't want to stay in the correct angle so it didn't illuminate the whole path. To be honest, if I didn't have a MT in my pocket, I was just going to leave it for... sometime later

Good usage DavisNikolov
:D -
I used my Charge's diamond file to make the Rebar lanyard loop just a little thinner, and put it in place of the thick washer.


-
Nice job, RP.

If it only came from LTG like that but, alas, it will take some of the Free's and Wave's sales and probably that wouldn't be good for them.

-
We've discovered rats in a cavity wall. My BO surge has been used to cut through plasterboard and set traps and fitting a sewer valve. It needs a serious clean!
-
Used Vix Work Champ and a LM Signal to make a power extension cord.
Of course, it all starts with that beloved long Phillips for the outlet disassembly

Than a knife and a cap lifter for stripping those wires

Then pliers for crimping

Phillips again to put those wires in place

I needed to cut the wire, so Signal wire cutters came in handy. Did the job, but the wire slipped out of them due to it’s thickness

Here’s the final result

-
Nice, alexanderre!

I used my Leatherman Surge several times while making this PVC sharpening jig. The Surge is featured in the video below the pic a couple times.

-
Good ingenuity!

-
Good job on both the angle sharpener and belt clip, PiOT; I think I'll copy it!

-
Thanks guys

-
Great ideea.
Well, as i had to sell my Leathermans, trusty lone Squirt is there in my small projects. Used ot to cut in half a 1m brass rod, for easier transportation
-
I used my Crunch to help take apart my crusty Dollar Micra.

Here it is finished

Sent from my iPad using Tapatalk
-
Good use of the ziptie as well

Badge worthy :D
-
I Ike to zipping a wrench on other wise I am forever dropping the wrench. After I get the screws broken lose I to use these engineer pliers. They work great! engineer pliers japan
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login