Thursday Surgeday
-
Glad it worked
The oil will keep any residual water left in from forming rust but the sun bathing will help get all the moisture out even better 
-
I've not been on here for a few weeks as work is getting rather chaotic at Heathrow (red list terminals and a distinct lack of staff ::) )
Whilst at work I gave the OG Surge a sharpening and then it hung out with some friends in the tool room

Stay safe out there awl...


-
Great pic, Surge
hope work calms down for you 
I forgot to carry a Surge today

-
-
I sheath carry and never notice the Surge being any heavier in it than a Wave or a Supertool :D
-
-
That blackened lettering looks nice

-
I was glad I had the Surge in the car when we went for a picnic at the lake today...

-
Hope it was a great outing

Great pic

-
Poncho... it was great. -
Glad to hear it

-
TDSD



-
@Poncho65 said:
You can open most of the tools up and run it through a dish washing cycle if you have a dishwasher
If not then run hot water un a sink with washing up liquid, agitate the water and let it soak. Repeat the process and scrub it with a toothbrush this go round
after that, dry it and take some compressed air (canned or air compressor) and get all the water out then lube it back up 
You don't have to follow the first step of the soak but it does deep clean it a little more with the soak

Afternoon awl. I'm not carrying the Surge today as I'm using the OHT for the Daredevil challenge ;)
However, I collected my new B/O Surge yesterday and it is REALLY stiff (a bit like my joints these days ::) )
I recently followed advice from Poncho about cleaning my OG S/S Surge and it worked a treat (
Poncho)Question is; does the B/O stuff hold up in a dishwasher or should I hand wash and use some dry lube

As ever your collective wisdom is appreciated

-
Never ran a BO tool through the dishwasher

Glad it worked with the SS one though
I would just use a rag and wipe the tool down and then use dry lube 
-
@Poncho65 said:
Never ran a BO tool through the dishwasher
Glad it worked with the SS one though
I would just use a rag and wipe the tool down and then use dry lube 
I was thinking the same
I have removed as much of the standard shipping lube as possible 
However, I wasn't sure if another coating of dry lube would work, without removing the first

-
It should still work fine

-
TDSD 8)


Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login








