The October 2022 EDC Fixed Blade Challenge
-
LC and Alan 
I went for the one on the left, preferred the look of the moulded leather sheath and from a reputable seller I’ve bought from before.
It would’ve been a bit cheaper to get a synthetic sheath but the leather looked a much better betGot a bit of a discount on the advertised price too thanks to eBay plus, so seems good value….looking forward to trying it out

-
Day 07



Today is this number, I think this came off of a seller on Instagram? No idea to be honest. I did have to hand grind a new bezel into it for a past challenge, as the edge was way too fat to be productive, and I gave the kydex sheath a faux leather covering with sofa fabric, held in place by that small piece of ball chain. I really like this knife, I just wish it was a smidge, like a cm or two longer in the handle.
-
Day 7
glam pic<a href="https://flic.kr/p/2nRvxwU" target="_blank" rel="noopener noreferrer"><img src="https://live.staticflickr.com/65535/52412457300_f77608aee1.jpg" alt="banner" style="max-width: 100%; height: auto;" /></a>20221007_183047 by Humayd a r Mahomedy, on Flickr
-
@Alan K. said:
I knew the handle on the bobtail was longer but the picture makes it look as though the blade is also a little longer, unless that is just from the camera angle. I haven't seen them side by side before. Thanks.

Pretty sure the last pix should present them correctly, but here is another picture taken for size comparison. I'd make sure the pix is taken further away(to eliminate close range lens distortion) and keep the phone camera level. The Bobtail does have a larger blade, and larger handle. -
Day 8



Since I was doing a comparison photo for the Brisa Bobtail and Necker, I figured I would do another one for these two--the Mora Garberg and Condor Terrasaur.
Before the Garberg, I think many Mora fans had always wanted a 'full tang' knife from Mora and IIRC, it made quite a buzz when it was first released. It was quite functional as a full tang knife, but not what I have expected from most of my Mora knives experience, lightweight and well balanced.
Then came the Condor Terrasaur, which is heavily inspired by the Garberg. To some extent, I think it is an interesting offering. The fit and finish is no where near Mora level, but it was nearly half the price. The weight is a lot less while maintaining full tang, the blade stock is slightly thinner(2.83mm vs 3.2mm on Garberg) and balance is better in hand. To some extent, it is the format I wish Mora Garberg would have presented in.
But would I recommend this over the Garberg? The answer probably will depend on personal preference--if you have a large size hand, and don't mind a little extra weight or balance biased towards handle, then Garberg is probably a good choice if you don't mind the higher price tag. If weight and balance is first of higher priorities, or don't mind trading off fit and finish for a lesser price tag, then Condor Terrasaur indeed will be a better choice.
-
Day 8:
Cutting open some sausages for the grill:

Sent from my iPhone using Tapatalk
-



Since I was doing a comparison photo for the Brisa Bobtail and Necker, I figured I would do another one for these two--the Mora Garberg and Condor Terrasaur.
Before the Garberg, I think many Mora fans had always wanted a 'full tang' knife from Mora and IIRC, it made quite a buzz when it was first released. It was quite functional as a full tang knife, but not what I have expected from most of my Mora knives experience, lightweight and well balanced.
Then came the Condor Terrasaur, which is heavily inspired by the Garberg. To some extent, I think it is an interesting offering. The fit and finish is no where near Mora level, but it was nearly half the price. The weight is a lot less while maintaining full tang, the blade stock is slightly thinner(2.83mm vs 3.2mm on Garberg) and balance is better in hand. To some extent, it is the format I wish Mora Garberg would have presented in.
But would I recommend this over the Garberg? The answer probably will depend on personal preference--if you have a large size hand, and don't mind a little extra weight or balance biased towards handle, then Garberg is probably a good choice if you don't mind the higher price tag. If weight and balance is first of higher priorities, or don't mind trading off fit and finish for a lesser price tag, then Condor Terrasaur indeed will be a better choice.
That is a nice comparison. I’ve read a few reviews of the Garberg,because I was considering it at one point. It seems many reviewers felt unless you were really planning on hard use that required full tang, the Kansbol would meet most requirements while still being light.
-
@Alan K. said:
Have you tried making the picture smaller. Sometimes that helps. By the way you didn't post a day 5 picture either.I did try making the picture smaller but it just came up with an error.
As far as Day 5, I must of enjoyed my breakfast so much I forgot to post.
Day 5
The ATK opened the cheese, bacon, and tortillas; while the wife did the cooking

Day 7
Because the one picture didn’t load, I took a glamour shot while out walking

Day 8
ATK opened up a box of some medicine for Fisher.

-
At 23:40 last night AlanK offered his insights, at 23:59 EchoTech says he pulled the trigger. Very shortly after that reviewed my two choice on the big River site and shortly after midnight I too pulled the trigger and a reply received indicated item would delivered by 22:30, 10/08/22!!! 
Well they were right, at 12:08, e-mail received, packaged delivered. Same Day🤪
[attach id=0 msg=2372793]
Buck El Morro welcomed new sharpie to the nest!

-
Day 8 -
A new family photograph,
[attach id=0 msg=2372794]Action shots of El Morro hoped for later today after some errands completed, mean while it will ride in front right pocket. 😜
Note to self, reduce time on MTo

-
Very nice pick-up LC
-
Who knew this would turn into the Sharpfinger challenge? :ahhh
-

BLJ got used to clip some twine and open a new package of 'dog' treats, but the camera was not at hand.
So, simple portrait shot for me again.Have to say, the utility style of this Sheepsfoot blade (?) is great to use. Turning out to be a very handy EDC.

-
Day 8, opened a package with the Military Green Mora 511 Basic.
The wrong item showed up.
Believe this to be Raven from the previous iteration of the animated Teen Titans series. I put my photo through Google Lens--Made by Bandai in 2003, and seems like it is a somewhat rare figure.

This was what I actually ordered. Hoping this gets straightened out, especially given I paid $20 for the pair (after counter-offering the seller's $30 offer), and they aren't easy to find. While Schylling produced the Rodeo Champions line for at least 3 years (2007-2010), they don't show up too often.

Seller says the item was intended for another customer. They at least are paying for the return shipping, but I'll likely have to use my own shipping supplies, as the seller just used a flimsy, thin single-serving popcorn snack box.
The seller said that once they received the item I was supposed to, they'll relist it. But after this snafu, I'm not sure if I will repurchase it. Both the seller's instances of negative/neutral feedback were due to the wrong items sent. What is also annoying is that the items I bought were the only ones I found available for sale of their type.
-
@LoopCutter said:
It is GA1dad’s fault, he is such a trend setter and his BBQ talents…I took an informal poll to figure out who's to blame here....

-

Congrats LC, good work GA1dad

-
Day i
ProS sunset dusk
-
2022 EDC Fixed Blade Challenge
Western 66
Day 8@LoopCutter said:
It is GA1dad’s fault,Who?,,,, Little ol' me??
@Nix said:
Who knew this would turn into the Sharpfinger challenge? :ahhhHmm,,, that would be a good looking badge for a future challenge.
Looks like we Sharpfinger owners are growing in number recently. 
This is kind of awkward now, as I mixed it up and carried a Western today,,,
Thought I might carry a Western this whole week.My daughter wanted to make a wooden staff for her Halloween costume. She went out in the woods and picked a branch, then asked if I could skin the bark off. Since the branch had been dead a while, the Western 66 made easy work of it.
.jpg)
-
That is the story of my life🙄, I get in line with the TREND SETTER, and they go with a new item! 😉
Actually the Western is better suited for skinning a tree branch, and whittling the top there for a more comfortable hand hold!
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login

