Quality torx screw's?
-
Yes, I only had to peen one side...oriented the factory heads to the front.
-
I saw the suggestion of silver, but why stop there? How about a metal that is "silvery-white in appearance, lustrous, ductile, and malleable. It does not oxidize at any temperature." It also is "well suited for making fine jewelry," and "possesses high resistance to chemical attack, excellent high-temperature characteristics." Sounds perfect right? Well platinum is the metal for you.
-
Not totally on topic: I've been searching high and low for some 4mm pivots like the one in Neil's pic, but to no avail. The plan was to replace the pivot pins of my older Spirit with these to modularize it and, if things turned out ok, then do it to the rest of my Spirits. That would allow for some interesting SOG-like modding and make adding a pocket clip a breeze... :-\
-
@SporkBob NoPants said:
I'm pretty certain that the Alox knives use nickle silver pins. I reused the pins from a Farmer to re-assemble my old Electrician.I'd say you're right, I certainly noticed the difference when doing my Cadet mod.
Mike, I'm afraid to say I've had absolutely no joy in finding any screws small enough for doing SAK mods. Really wanted to try for something modular as well but no luck. :-\
-
I think that a modular SAK cannot be built without a lot of effort and modification.
If you could drill out the tangs smoothly and precisely, you could probably use commonly available pivots. You would then have to have a set of pivots of the correct width for each and every layer combination you want to use.
That doesn't address the problem of the center backspring pivot...there is not enough material there to drill out.
I had the ideal a long time ago of a Hobo knife type arrangement where the knife could be split in half for use and to attach different tool sets...that will happen as soon as I get a lathe and a mill set up in my living room ::)
-
@ari6126 said:
Would these work?
http://www.fastener-express.com/index.asp?PageAction=VIEWCATS&Category=245Guy's ???
-
Perhaps.
I'm put off by the idea of having a tool that pivots around a set of threads. My worry is that the threads would give up the ghost very quickly. If the P&P isn't much it might well be worth playing with though. -
I've put a 111mm together on threaded bolts before but that was only as part of an experiment not intending to actually use it like that.
I'm not sure of long term viability but in the short term it should work fine. Hmmm

-
@Gareth said:
I'm put off by the idea of having a tool that pivots around a set of threads.That is my first thought too. I discarded that ideal over 15 years ago when I had free access to high-quality Aircraft and Instrument hardware like that. :P
Maybe I should have put one together then to see how it held up...
-
What am I missing here? You don't want a SAK with a couple of big frankenstein bolt-heads sticking out the side do you? ??? And what would the bolts thread into? Big frankenstein nuts on the opposite side??
-
Heeeeelllllooooo! You've taken the dive then have you mate?! Good show!
Can't wait to see how you button her up. :)Tell me though if you will, what diameter were the original pins?
-
Are you going to rivet with stainless rod Neil?....You might need a bigger hammer :D
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login
Like this :D