Scale Polishing
-
I've been reading old posts about polishing scratched up cellidor scales and thought I'd give it on an old scratched up Fisherman I inherited from my workplace's Lost & Found. Here are the before and after shots!
It had quite some scratches and appeared more matte before, but I tried rubbing it against my mousepad untill it has some shine.
I used wet sandpaper 320>600>800>1200, then Meguiar's Scratch X to buffer and it really brings the shine back to it's glory days!
I can't seem to remove the tiny scratches though. Is it because I didn't sand enough, or did I use a wrong cloth?
I used a fuzzy microfiber cloth to buffer the scale.Or is it never possible to restore it to its brand new state again?

-
I usually do it almost the same way you did. I wet sand with 800+1200grit with a erasing gum as a block. Then I polish with boat polish on a rubber cloth. But... The deeper scratches you have left is because you did not sand them off in the first place. I have succefully restored celidor before, using acetone. Acetone will desolve the scale material, so just put a drop on the deep scratch an blow it dry. Do not wipe it. The scale will look melted where the acetone was, and then start sanding again.
-
@BarbaBaba said:
I usually do it almost the same way you did. I wet sand with 800+1200grit with a erasing gum as a block. Then I polish with boat polish on a rubber cloth. But... The deeper scratches you have left is because you did not sand them off in the first place. I have succefully restored celidor before, using acetone. Acetone will desolve the scale material, so just put a drop on the deep scratch an blow it dry. Do not wipe it. The scale will look melted where the acetone was, and then start sanding again.Thanks for the tip BarbaBaba!
Ah so I actually need to put in a lot more sanding then! It always looked as if it's smooth enough between sanding.
Would isopropyl alcohol yield the same results too?
-
@MuSAKcian said:
Thanks for the tip BarbaBaba!Ah so I actually need to put in a lot more sanding then! It always looked as if it's smooth enough between sanding.
Would isopropyl alcohol yield the same results too?
I am not sure about the alcohol, but it might. Just be careful so you don´t melt them ;)
-
A very nice polish job!
As for the alcohol, I think I've gotten it on Cellidor with no adverse effects. Maybe I'll leave some old scales in alcohol for a while and see what happens. -
Sometimes I use alcool to clean the knifes and it leaves marks on the scales. I usually use a cloth or a piece of paper to polish the scales and they are like new
-
Isopropyl alcohol does not play nicely with cellidor scales, in my personal experience. The higher the concentration, the more quickly it degrades the scales.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login