Wave Interior Tool Mod
-
Finally got around to building a modern version of the original Wave. I like the idea of having the awl and dedicated Phillips on a tool I can use outdoors without losing bits.
Tools: can opener + Phillips and pry bar + awl + scissors.
[attach id=0 msg=2447004]
The issue: tools overlap with pliers stop bar. The solution was to snap off the pliers stop. But, there still isn’t enough clearance. I think it’s the rest of that piece causing the implements to sit too high.
So, pliers won’t close.
[attach id=1 msg=2447004]
I think I need to file down the rest of that stop. It should work. The only other fit issue is the awl sitting on top on the scissors, so awl has to come out to get scissors. Otherwise works great.



-
It's been a while so I could be way off here.
Pretty sure the Phillips is short enough to clear the Scissors handle so try swapping that over.
If grinding down the rest of the plier stop doesn't work then option two is remove it completely.
Remove the pliers, grab ends and lift up and out. Re peen the rivet for the inner tools lock spring. -
I know for sure that you can get phillips side go lower by bending little tab inside handle or just breaking it like in picture ( upper normal Wave and other is my modded Wave)

Otherside isnt so easy cause profile of awl prevents pliers go any deeper even if you cut that tab ( i have tried in both handles and same result) only way to make pliers and handle close properly is modding awl profile and if you want to close it like normal wave maybe also profiling phillips needed to vlose fully.

Difference with our mods i didnt keep scissors but instead microbit driver.
As you can see my wave dont close fully but its so small gap that i really dont care it even if it wont close properly causd i really do t wanna reprofile awl ( awful lot work for reprofiling it, cause need to make it by hand and not with tooös cause heat treat might go wrong)

Only Tools Matters
-
Oops, nothing to add to this thread.

-
@zoidberg said:
It's been a while so I could be way off here.Pretty sure the Phillips is short enough to clear the Scissors handle so try swapping that over.
If grinding down the rest of the plier stop doesn't work then option two is remove it completely.
Remove the pliers, grab ends and lift up and out. Re peen the rivet for the inner tools lock spring.@Antti Lammi said:
I know for sure that you can get phillips side go lower by bending little tab inside handle or just breaking it like in picture ( upper normal Wave and other is my modded Wave)

Otherside isnt so easy cause profile of awl prevents pliers go any deeper even if you cut that tab ( i have tried in both handles and same result) only way to make pliers and handle close properly is modding awl profile and if you want to close it like normal wave maybe also profiling phillips needed to vlose fully.

Difference with our mods i didnt keep scissors but instead microbit driver.
As you can see my wave dont close fully but its so small gap that i really dont care it even if it wont close properly causd i really do t wanna reprofile awl ( awful lot work for reprofiling it, cause need to make it by hand and not with tooös cause heat treat might go wrong)

Only Tools Matters
Thanks, Zoidberg and Anti Lammi. These are helpful suggestions. I will try some further modification.
Fully closing the pliers would be ideal but also doesn’t render the tool unusable.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login