Argument at Zuckercorp
-
Rusty Spirit
.jpg)
.jpg)
-
Since we have no idea what this Spirit went through to get to this state, this means very little to be honest.
As many others here I own my fair share of multitools from different brands, and my tools are all stored in the exact same way, at the exact same location. And I know I have to check my Leatherman collection at least twice a year to make sure they are still fine, using a special little brush to remove any little brown dots that may have formed, and oiling them up again.
Never had to do this with my Victorinox Collection, I used to check them at the same time when I checked my Leatherman tools, but now I find myself only checking them once every 2 or 3 years or so, and I never found any rust on them anyway. Does this mean they don't rust? No, they do.
I bought an old, heavily used Swisstool which was so dirty that I left it in a bucket of water with some soap, hoping to soak the dirt of, but I forgot to take it out and about 3 or 4 days later, when I finally took it out, part of the water was gone and the Swisstool had been exposed to water and air, and it had developed rust, especially around the pivots, and on the ribbed pieces used to unlock the tools. It did come of, but yes, they do rust.
Do I believe Leatherman tools to be inferior to Victorinox tools? No, in fact, I've been carrying my Wave + for a couple of years now as daily carry, along with my Swisschamp. Why these two? Well, together they cover just about everything I come across, and more importent, both were purchased locally and are still available at the same shop, so dealing with warranty, or even replacing them would be very easy to do.
I absolutely love the BO Charge Plus I bought on Ebay USA (I actually bought two, with the help from a member here ;)), but replacing that one over here would be quite impossible, so I choose wisely when to carry it, and when not to carry it.
I believe we are spoiled with so many capable tools, so much that we can actually nit-pick on every weak point they might have, even though each tool could deal with 99% of the stuff we throw at them.
When I go hiking and it might get humid and wet, I carry a Spirit or Swisstool (mostly because they are quite rust resistant, and they don't have any loose parts, like bits or mini screwdrivers that could get lost). I carry them along with my Swisschamp, and when the hike is remote enough, I'll throw in my stainless Mora Garberg.
When I have to do some chores around the house/garden, the Supertool 300 is by far my favorite, followed by the Surge.
Oh, and compared to my Tops Knives Tanimboca Puukko fixed blade in 1095 steel, Leatherman tools are very rust resistant. I swear I've seen that Tanimboca Puukko rust while just looking at it (yet I absolutely love it, I just need to grease it up regularly :D).
Apologies for my long, incoherent rambling...
-
Appears to be. It’s not a big deal, it’s not rusting out. Some leathermans seem to be less corrosion resistant than Victorinox. Steel with a bead blast finish is going to attract rust in my experience. I polished a Cold Steel Espada that was bead blasted because I couldn’t have it in my pocket without it rusting.
-
@G-Dizzle said:
Appears to be. It’s not a big deal, it’s not rusting out. Some leathermans seem to be less corrosion resistant than Victorinox. Steel with a bead blast finish is going to attract rust in my experience. I polished a Cold Steel Espada that was bead blasted because I couldn’t have it in my pocket without it rusting.boom. nailed it.
-
The original statement seems to disregard that a critical feature of multi-tools is exactly weight and volume, and that is a gradual thing. To make a pointed point you could just as easily say that except for weight and volume a multi-tool can't compare to a set of dedicated tools.
I usually prefer a SAK when I don't need a plier simply because I can carry it in any pocket without issue. The same can't be said for the big Leathermans or Victorinox Spirit or Swisstool. I would also give tool finish/ quality check as a plus for Victorinox, but that is just based on the products I got from both.
-
It's one thing to have a preference.
It's another to belittle others for their preference.
Unless they prefer Schrade. Then it's okay to judge them harshly.
Def
-
@Grant Lamontagne said:
It's one thing to have a preference.It's another to belittle others for their preference.
Unless they prefer Schrade. Then it's okay to judge them harshly.
Def
hey wait… 
I’ve been going back and forth between a Spirit and Wave for my outdoor work this past week. It really is a matter of preference. And, I keep thinking I prefer a Spirit!
-
@Grant Lamontagne said:
It's one thing to have a preference.It's another to belittle others for their preference.
Unless they prefer Schrade. Then it's okay to judge them harshly.
Def

Both are great quality tools and have their benefits.
I love the Spirit for a combination of ergonomics, all tools being accessible from outside, and the chisel tool.That being said I can recognize that most Leatherman seem to be better for hard use and better knife blades.
-
Most of you have never had to field repair a leaky old tractor and it shows.

When I was evaluating the Vic Spirit for farm EDC, I was battling algae in fuel tank (side note: Biodiesel can be quite plague-y). Pull the line, isolate the plug, blow the line (cans of compressed air are a lifesaver) and put it all back together.
That super shiny Vic finish is so slick with a bit of diesel on it, that it made it quite a chore to tighten hose clamps and tighten bolts. Add to that, trying to open the nail nicks for the drivers, and you have an unnecessary frustration. The rougher finish on a Charge is much more forgiving and the bit drivers are easier to deploy with slippery fingers
-
Make fun of Gerber all you want, but at least I don't have to sell my car to afford the new Gerber models....
Plus they seem to understand that "innovation" is about making a tool with functions that weren't previously available, not just adding fancy materials as a way to jack up the price!

Def
-
I was a large building maintenance engineer for nearly 20 years. Heating, hot water, lighting, HVAC, pool plant, plumbing, industrial kitchens, joinery, painting etc etc. All my MTs were used hard almost every single day, including the Spirit, Leathermans and Gerbers. I am more than qualified to have an opinion on any and all MTs I used. :)
-
I think Howard Lees is either on drugs, doesnt know knives or both
Ranting on a brand like that tells me more about the person in question than the brand he is looking down on.Of course a Victorinox can compete with a Charge... but it will be completely up to the judge who will be the winner. Both companies produce quality products that excel in different ways. But we all know this, i feel like im preaching to the choir 😅
-
Agreed completely.
Tragically Leatherman is now being seen more as a status symbol than a real, actual working tool, and I think that gives rise to this kind of attitude.
Def
-
@Grant Lamontagne said:
Tragically Leatherman is now being seen more as a status symbol than a real, actual working toolI say this as someone who, in spite of not being a big fan/heavy user of PBMTs in general, likes LM, owns a handful, and uses them sometimes…
To whatever extent this may be happening, I feel like Leatherman is largely making their own bed.
I realize the inflation bug has bitten everyone, but if I’m considering spending much more than $150 (and definitely if it’s over $200) on a knife or MT, I’m going to be asking some tough questions along the lines of “What am I really paying for?” and “What makes this tool worth this kind of money?”
And if I do buy it, I’m going to expect a product that closely approaches perfection.
-
Almost feels like an Apple vs Samsung situation. Both make quality phones but youll pay a premium for one of them just because its an Apple product.
:ahhh
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login




