Sad SAK Saturday
-
It is Sad SAK Saturday again. Sad SAKs don't really have to remain that way. I will show one that I snatched from the Green Ripper and brought back to life.
This one had a bunch of problems. No scale tools (which always makes a SAK look haggard.) Big blade was bent and scuffed. Screwdriver tip on can opener was twisted. Someone did lots of prying with this one. Scales were scuffed and had a large cut in them. The cut went up one scale and even cut through the little metal inlay. Scales were loose and the whole knife was dirty.
Rehab included sanding the scale so the cut is much less obvious. I hand straightened the kink in the big blade. A little metal polish here and there and a good clean and oil. Scales were glued to remove the rattle and polished. New scale tools. The knife looks pretty good now. No longer sad. I have a couple of after photos. Best wishes. G
:D [attach id=0 msg=2494000] [attach id=1 msg=2494000]

-

Nice refurb job there!!!
One of these will donate the can opener to a Climber, and the small blade to an Explorer.
[attach id=0 msg=2494009]
-
That's another great use for a Sad SAK. Parts donor. Of course, those two look pretty nice. Be sure to post the results after the transplant. Best wishes. G
:D -
Not an SAK, but I think this fits.

-
You must be in a damp/maritime climate. There have been quite a few Leatherman multis on here with the rusties in various stages. I like to use a stainless-steel rotary brush in a Moto-tool to whisk away the corrosion. So far I haven't had rust problems with any Leatherman, and this is generally speaking, a damp climate. Best wishes. G
:D -
Two sad SAKs right here. One of them was a real nail breaker.


-
@IMR4198 said:
Sad SAKs don't really have to remain that way.Nice job on the rehab!

@Juan el Boricua said:
One of these will donate the can opener to a Climber, and the small blade to an Explorer.I'm with Gary: those look almost too nice to be parts donors.
After an extensive cleaning, it'll be good to go!
@AzteCypher said:
Two sad SAKs right here.Shame about the orienteering tool!
-
What is the deal with the pivots on the SAK with no scales? Hmmm? Best wishes. G

-
There looks to be some aluminum oxidation and perhaps some dirt. I'm hoping it just needs a real good cleaning and some oiling. I have a few others ahead of it that I've been working on cleaning, oiling, and sharpening but I may just work on this one first as I feel bad for it. Even with pliers I struggled to get the tools open.
-
Might as well post a Sad SAK for today. I am actually carrying this one. I kept it out of the Surprise Box so I would have something I wouldn't mind scuffing up in my always questionable pockets. For the Delemont challenge of course. This is the good side. The other side is missing a scale. Tools have various issues. Completely usable regardless of appearance. It is a Wenger Handyman. Best wishes. Gary
:( [attach id=0 msg=2494939]
-
Do you have plans for scale replacement? New old stock Wenger scales, unfortunately, are quite hard to find. -
I will likely make a replacement for the missing scale. Not a high priority at the moment. I planned on carrying the thing during the Delemont Challenge but have since reconsidered. I will go with a different Wenger, I think. Best wishes. G
:D -
I'll readily admit, that this one isn't as sad as the others I've posted. However, being that it's an executive (and they are in short supply) I find it extremely saddening to see it in this condition. Though it does look like the previous owner tried to rectify the travesty by reshaping the orange peeler. The complete specimen is above and the atrocity is below.


Yes, I understand I may be nitpicking...
-
Someone gotched it up. A little. Still qualifies as a Sad SAK in my book. Incidentally quite high in the desirable carry index. It finally rained a few weaselly dribbles. Not even enough to get the grass wet. I noticed that all of NC was taken off the drought designation, due to heavy tropical downpours. There wasn't as much as a dark cloud here.
Let's see..... I did the Delemont, See-through, and some other odds and ends. Time to post a 108 entry and then fix some breakfast. Best wishes. G -
@AzteCypher said:
I find it extremely saddening to see it in this condition.It could be worse. Maybe Victorinox USA has a few replacement orange peeler on hand?

@IMR4198 said:
I noticed that all of NC was taken off the drought designation.That's a good thing!

-
A F/U to posts #21-22
Two down, and one to go. The "sacrificial Spartan" gave way to a new can opener to the std. Climber, and the corkscrew to my Deluxe Climber clone; still pending the small blade into the Explorer.
[attach id=0 msg=2495389]
-
I picked up this Wenger to carry during the Delemont challenge, but decided to EDC a Wenger Esquire instead. It has various issues. No scale tools, no scale on one side, etc. Still makes a perfectly usable pocky knife. Just a little sad. Best wishes. G
:( [attach id=0 msg=2495829]
-
Got this early 80’s Sexplorer Hoffritz edition today for $26. Not in love with it because it’s too thick to carry. Probably going to sell it

-
Sad SAK at the laundromat. I think this was the grittiest knife that I have ever owned. I did a full body wash on it twice, and it was still gritty. Then I scraped the liners with wooden splints that were whittled from toothpicks and brushed the tangs with a toothbrush. Oh, I would say a couple of hundred times. Finally the black grit is at least partially gone. I thought about tumbling it wet in a rock tumbler, but there is abrasive embedded in the walls of the tumbler drum. Might do it anyway at some point. Best wishes. G
:( [attach id=0 msg=2496703]
-
With the missing scale and all the grit and grime, that's definitely a project SAK!
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login