Spyderco Byrd Wrench
-
Wonderful pictures and descriptions Tom. Don't sell yourself short, I think it was worth at least 75,000 words, maybe 80,000.

I was holding my SpydeRench in my hand as I read through your review. I see a few minor differences, like the Byrd logo instead of the Spyderco spider. I think the only significant differences are the magnetic bit driver (instead of the Spydie's detent driver) and the round rasp.
It seems like the rasp would be limited in it's usefullness, to put it politely. I suspect the old three-sided diamond file was deemed too expensive, but a fine-toothed file seems like it would have been more useful?
-
I was thinking about the rasp too & was lamenting that it didn't have the diamond file. As I thought of it for my uses I may end up using the rasp more often than a diamond file though, so I'll be okay with it. I did think of modding a diamond sharpening rod to fit into the same spot though.
One question - does your SpyderWrench have a lot of friction in the outer of the two positions in the slip-joint of the pliers? Mine binds quite a bit in that position, but I thought it might be to keep it from rattling. In the inner position it moves very freely as you would expect.
-
Mine swivels freely in both positions. However, I just am now noticing that the pivot T-stud on mine has been ground down (very slightly) around the edges. This work looks to have been done by hand, probably in order to allow it to move without binding in the round pockets.
Can you see any shiny spots on yours where it is rubbing?

-
-
@Tom Munch said:
I was thinking about the rasp too & was lamenting that it didn't have the diamond file. As I thought of it for my uses I may end up using the rasp more often than a diamond file though, so I'll be okay with it. I did think of modding a diamond sharpening rod to fit into the same spot though.That would be interesting. Or how about maybe a firestarter ferro rod?
-
-
-
great pics, have to thake an closer look on that one. is the price out jet?
-
-
@kimjune01 said:
I thought the new ones were made out of AUS-8 or somethin
am I wrong?There's a SpydeRench and a ByrdRench. Byrd is the "economy brand" of Spyderco. I posted some photos of the SpydeRench here: /topic/1995. The construction of the two is quite similar but there are a few differences:
original SpydeRench: manufactured in USA, 440C blade steel, diamond file
new SpydeRench: manufactured in Taiwan, AUS-8 blade steel, diamond file
new ByrdRench: manufactured in China, 8Cr13Mov blade steel, rasp
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login