What did you use your Sak on today?
-
Trooper went along on a snowy walk with my Ames square end shovel. Cleared the snow berm from around my mailbox. Snow plows leave a mound. Got tired of that and toddled home. Best wishes. G
[attach id=0 msg=2513437]
-
Found a car at my mailbox. Probably tossed from a school bus. Hot Wheels with Trooper. Best wishes. G
[attach id=0 msg=2513561]
-
Stay warm out there G!!

-
Oh... Spartan! Blade to open mail, small blade to open starched closed button holes, pin for eye drop bottle opening, toothpick for, well, tooth picking, tweezer did not grasp the offending hair....
-
Used the Swiss Grip to mount an eyelet to a painting.
[attach id=0 msg=2521721]
-
Tightening the valve on the ball pump.
[attach id=0 msg=2522911]
-
The Yeoman cut some treats for Fisher’s (my dog) Jump N Jack for when he gets left home. But the picture is of the drink from dinner.

-
My wife got this bike trailer off FB Marketplace for a song, we're excited to use it with our little one. Whoever had it before must have been a bodybuilder that stem cap was on so tight. The Deluxe Tinker pliers worked like a charm.
.jpg)
-
Pliers on my Spirit to take a couple chards out of the back tire on my bike.
-
Hope bo patching or plugging were needed!
-
<u>DAY 26</u> Yellow Hiker helping with some morning stuff.
[attach id=0 msg=2524400]

-
Used the large blade on the SwissChamp to cut some cord to hang a banner.
As I was at the top of a ladder at the time, no picture. :(
-
Main blade 3x
Scizzors 3x
Tp 1x
...and that's with the trusty red Classic
-
Pliers on the Spirit to Open an Back of Bee Smoker Material to Pack in smaller Packs , and the Paket Opener Edge to open 2 Packages at work, also 2 days ago the Pliers to make a bend Key for our Market Money Cassette back to flat .. and I did open a Bottle of Bear for my Dad as I don’t Trink Alkohol, whit the Bottle Opener which works just the same as on an normal SAK..

-
Flat driver to open stereo cans, blade cuts food wrap and string, pen on Weekender plus to pay for it!

-
I used my 84 mm Climber while replacing a forklift motor controller with one that had slightly different bolt hole spacing. I stripped some narrow gauge wires with the stripper, cut some electrician's tape with the scissors, and then used the awl to scribe which bolt holes needed to be adjusted and by how much.

-
Used the main blade on my Spartan to cut an old shoelace serving as a secondary latch on a gate.
Honestly, I was too lazy to grab the rigging knife out of my tool roll...
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login
