Opinel Knifes
-
Of course its really easy to make any opi non-locking. Just pull off the locking ring or shove some epoxy under it. Job done :D
Neil
Is there much of a snap on it when you do that? Don't want it folding up on her dainty little fingers :o
A non locking opinel :o good god no! Those rings are there for a purpose. Opinels are great knives but they are lethal when they decide to fold up on you! Son of Hedge Kid nearly took the end of his finger off with one of those forgetting to put the lock on. Doh!
[quote author=Gareth link=topic=10872.msg203113#msg203113 date=1241687940]
Essentially they become friction folders. You can give the pivot pin a bask if it becomes a bit loose. As with all non-locking knives they are perfectly safe as long as you remember they are non-locking.I didn't realise you could tighten them up - that might help save a few plasters :)
I did that with mine, turned it into a nail breaker, took a lot of work to made it loose again.

Yes, just a very little
baskbash would do it.I believe the "traditional" way of opening the knife is to tap the heel of the knife against something (your shoe I think) making the blade come clear of the handle. Then you have a lot more to grip rather than just using the nail nick.
[/quote]We used to use opinels all the time on the farm and when they get cacked up with mud and other detrius they refuse to open. In addition to Gareth's explanation above - tap it hard on a hard surface (wood) if that doesn't work, spray some WD40 into the pivot joint, rest the tapping point on the bench and gently tap the back of the tapping point with a hammer. You can interpret "gently" anyway you like depending on the age of the knife and your frustration levels >:D They can take a fair whack. If you value your handle, put a piece of wood between the tapping point and the hammer as your frustration increases.!
-
Dead good knives :) Got a stainless No.8 from the last time I was in France. Etched the blade and carved the grip a little. They're supposed to seize up a little if they get damp, but I waterproofed the top with Vaseline (spread it on to the top liberally, gently heat with a lighter until it gets thin enough to sink in, wipe off excess) so I've never found that a problem. They take really good edges with little effort, even the stainless ones.
-
@BenH said:
Dead good knives :) Got a stainless No.8 from the last time I was in France. Etched the blade and carved the grip a little. They're supposed to seize up a little if they get damp, but I waterproofed the top with Vaseline (spread it on to the top liberally, gently heat with a lighter until it gets thin enough to sink in, wipe off excess) so I've never found that a problem. They take really good edges with little effort, even the stainless ones.I want to buy a Opinel 12 as a bag/pack cooking knife, but I'm worried about getting the handle wet. What is the best way to try and waterproof the handle? I've seen some of the ideas here and they look pretty good, but what if I wrap the handle in duct tape? I just need to be able to clean the knife after cooking.
Anyone use a 12 for cooking?
-
John, it sounds like you need a large Cold Steel Twistmaster
:DSorry John I couldn't help myself. :D
-
I used mine a bit to carve turkey this Thanksgiving past. I usually just stick the "blade" in hot soapy water
and just run a damp rag over the wood. It might stiffen up a bit but usually goes back to it's normal ease
of open in awhile.
I have one Opinel and love it. I did mod the handle on it for comfort. The older it gets the more character
the blade seems to show. -
I saw a #12 slim the other day and it was preeeeeeeeetty, but at $40 it's hard to justify for an opinel.
-
Dead good knives :) Got a stainless No.8 from the last time I was in France. Etched the blade and carved the grip a little. They're supposed to seize up a little if they get damp, but I waterproofed the top with Vaseline (spread it on to the top liberally, gently heat with a lighter until it gets thin enough to sink in, wipe off excess) so I've never found that a problem. They take really good edges with little effort, even the stainless ones.
I want to buy a Opinel 12 as a bag/pack cooking knife, but I'm worried about getting the handle wet. What is the best way to try and waterproof the handle? I've seen some of the ideas here and they look pretty good, but what if I wrap the handle in duct tape? I just need to be able to clean the knife after cooking.
Anyone use a 12 for cooking?
GG something I learned for kukri wooden handles,place the handle in a jar of Raw linseed oil for 72 hrs and then in boiled linseed oil for a further 48 hrs then when dry use beeswax to finish off

-
Dead good knives :) Got a stainless No.8 from the last time I was in France. Etched the blade and carved the grip a little. They're supposed to seize up a little if they get damp, but I waterproofed the top with Vaseline (spread it on to the top liberally, gently heat with a lighter until it gets thin enough to sink in, wipe off excess) so I've never found that a problem. They take really good edges with little effort, even the stainless ones.
I want to buy a Opinel 12 as a bag/pack cooking knife, but I'm worried about getting the handle wet. What is the best way to try and waterproof the handle? I've seen some of the ideas here and they look pretty good, but what if I wrap the handle in duct tape? I just need to be able to clean the knife after cooking.
Anyone use a 12 for cooking?
GG something I learned for kukri wooden handles,place the handle in a jar of Raw linseed oil for 72 hrs and then in boiled linseed oil for a further 48 hrs then when dry use beeswax to finish off

John, if I do that can I wash the knife without the worry of the wood splitting? In other words, will it be a good food prep knife? Thanks for the tip!

-
Dead good knives :) Got a stainless No.8 from the last time I was in France. Etched the blade and carved the grip a little. They're supposed to seize up a little if they get damp, but I waterproofed the top with Vaseline (spread it on to the top liberally, gently heat with a lighter until it gets thin enough to sink in, wipe off excess) so I've never found that a problem. They take really good edges with little effort, even the stainless ones.
I want to buy a Opinel 12 as a bag/pack cooking knife, but I'm worried about getting the handle wet. What is the best way to try and waterproof the handle? I've seen some of the ideas here and they look pretty good, but what if I wrap the handle in duct tape? I just need to be able to clean the knife after cooking.
Anyone use a 12 for cooking?
GG something I learned for kukri wooden handles,place the handle in a jar of Raw linseed oil for 72 hrs and then in boiled linseed oil for a further 48 hrs then when dry use beeswax to finish off

John, if I do that can I wash the knife without the worry of the wood splitting? In other words, will it be a good food prep knife? Thanks for the tip!

Should be fine if done correctly and maintained what it does is seal the wood ;) what you could do if your not 100% sure is test the method on a piece of any wood first
this method is also great for restoring tired looking wood handles or scales ;) -
Splitting is never a concern with opinel I think, it's them turning into nail breakers when wet. To really waterproof it you will need to take out the pin, bolster and blade before doing any of that thou, may not be worth the effort.
-
The Olivewood handles seem to have fewer problems with swelling. I've soaked all of my Opis for several days in Boiled Linseed oil thinned with turpentine (to aid penetration).
It takes weeks to dry properly and it may be hard to open for a while, but now I have no more issues with the wood swelling. I suggest removing the locking ring and wiping all metal parts clean when you take it out of the oil...otherwise you will end up with a gummed up lock.
-
Do you remove the factory lacquer or leave it on when soaking?
-
Does anyone here have an Opinel Slim? If so, can I see a picture of it? It would be even better if someone could show me a picture of one beside a normal Opinel!
-
I've never seen one either

-
I've seen a couple in stores and the grind isn't as well done as regular opinels, could be just the ones I saw thou.
-
Wow what great knives these are. I got one a couple days ago and can't put it down. There is just something about these simple knives that draws you to them.


-
Yeah there pretty cool aren't they :)
There one of those rare item's where cheap, really is cheerful :)
-
I bought two of those back in 1981 when I was over there in the Navy. I lost one but think I know where the other is. All this talk got me to remembering some good times (before good knives were illegal over there).
:D
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login