Best MultiTool oil?
-
I've heard that mineral oil is good.
-
I use Breakfree CLP
-
I use Nano-oil on all my tools/knives and flashlight threads to,been using it for around 3 years now

-
-
Mineral oil for all my MTs and Moras.
-
-
Remington Gun Oil with Teflon. Works great on Glocks and Leathermans :D

-
Zoom spout oil, no smell and clear in color if that matters to you. I get it at Johnstone supply(HVAC supply house) but I think you can get it at Grainger also.
-
@Pacu said:
Remington Gun Oil with Teflon. Works great on Glocks and Leathermans :D
I hate that stuff. Years ago I got a bottle of it and it had this little straw that attatches to it and after I was done using it I was pulling it out and it flicked a little bit of oil in my eye and it made my eye red and I had to got to the doctor and get drops put in my eye to clear it up. Haven't used it since.
-
bet that eye open and shut alot faster due to the teflon

i bet that hurt though on a more serious note...petroleum product to the eye :'(
-
-
Haven't read the whole post, but I just use typical 3 in one oil.
-
As I've said, I use Mineral oil for all my MTs and knives. **Mineral oil is scentless, foodsafe, inexpensive, and easily available. **
Edged tools simply don't need oils/lubes like Breakfree or Remoil. But Breakfree is great for firearms.
-
THough some here may consider it heresy, but I use good old WD-40!

-
I know that the smell of WD-40 will dissipate after a few hours. But for those who use 3-in-1, does the smell go away? It's been a long time since I used 3-in-1.
-
@turnsouth said:
I know that the smell of WD-40 will dissipate after a few hours. But for those who use 3-in-1, does the smell go away? It's been a long time since I used 3-in-1.In my experience, yes.
-
I used to use mineral oil. but the pivots/hinges got all gummy

-
Synthetic motor oil also works good if you change you vehicles oil your self hold a little back for your oil bottle. For cleaning and rust protection i use W-W40. For cleaning i hose said tool W-D40 clean with pipe cleaners,tooth picks and Q-Tips. Then flush with W-D40 and then i finish up by removing the excess W-D40 with a air nasal or a can of compressed air. If you W-D40 is left in a thick layer it turns gummy but left thin it protects well and leaves a nice finish. In all the rust protection tests i have seen and done myself W-D40 fared well products like motor oil, Hopes gun oil, Breakfree, and Rem oil did not work well.
-
@shamus said:
Edged tools simply don't need oils/lubes like Breakfree or Remoil.I suppose that depends what you're intending to accomplish with the oil/lube. Breakfree will penetrate and remove rust, where mineral oil will only inhibit rust.
We're not just discussing just "edged" tools here, but multitools. I've purchased used multi-tools that certainly needed Breakfree.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login
