Bended corkscrew
-
Other than VERY slowly, no mate :-\
-
Don't think that will be much of a problem as long as you're careful. What you might consider doing is getting a pair of needle nose pliers (not a multitool) and using those to clamp down on the root of the corkscrew (the little matl part that has the hole for the brass rod), then clamping the needle nose pliers in a vise, HARD. That way you force it to bend the corkscrew, not the rest of the tool
-
I have bent them back before with 2 sets of pliers no probs. Just go slow.
-
could try and heat it up a bit then bend it but i suspect this might well ruin the sak completely
-
temper of a corkscrew

-
I have used the felinevet way with much success. Use a vice grips pliers and clamp down on the corkscrew base when in the opened position and take a large pin punch that will fit inside the corkscrew snugly and slowly bend it straight. Small movements and rechecking is better than a large movement where it might snap off.
-
@stressmaster5000 said:
I have used the felinevet way with much success. Use a vice grips pliers and clamp down on the corkscrew base when in the opened position and take a large pin punch that will fit inside the corkscrew snugly and slowly bend it straight. Small movements and rechecking is better than a large movement where it might snap off.So putting it in a vice and smacking the crap out of it with a hammer is bad? :( ... oh :-[
:D Tim's method as Wayne outlined above works very well. You should have it ship shape in no time

-
I clamp the base in a vise so that there is no strain on the pivot when tweaking the worm.

-
@Herman said:
This morning I picked up a Cybertool 34 without scales. It's in excellent condition except for the corkscrew which is completely bended. Does anyone know an easy way to fix this (without causing further damage)? Thanks!As all the other guys said, clamp the SAK and bend the corkscrew back to its original shape. But do it slowly! :)
VicX
-
Tadaa!!
It worked out pretty good, so I don't have to throw it away now :)
Thanks for your support

-
Good job!

I have straightened a couple myself. It usually works out pretty well as long as you take it nice and slow.
-
Good job mate

-
Thank you for these instructions.
I won a 1980's vintage Woodsman on E-bay about a month ago, and it had a bent corkscrew.
It is not 100% but I would give it a 98% bent back to where it needs to be. It no longer touches where it shouldn't. I do not want to go further, for fear of breaking a grooved and vintage corkscrew on a vintage Woodsman.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login
