Rough Rider with wrench RR1134
-
I've had one of those on my wish list for awhile dks, thanks for the review.
You say the wrench head is only attached to the handle with those two brass pins? Are you sure? There are other wrench-knives like this one, and they usually have the wrench head part of the center liner, which runs the entire length of the handle. -
@MultiMat said:
I think I may well still get one if I am buying something else from a seller that also sells these
:D.The seller I got them from, eBay has them on sale now

@J-sews said:
There are other wrench-knives like this one, and they usually have the wrench head part of the center liner, which runs the entire length of the handle.It is separate. The liners are brass; the wrench steel. The pins go through the whole knife. One goes through part of the knife spring too.
They could have made it in one piece with the screwdriver spring, if they wanted, though that would have been problematic with respect to the different tempering needed for the wrench and the spring.
The actual wrench head has slight sideplay, as it moves between the liners.
The problem I have with sloppy adjustable wrenches is that usually when you push hard they will let go, by a bit as the top part twists opening up slightly (slack), allowing the wrench to move destroying the bolt head and usually making me hit my hand on something hard and sharp. I do suspect, however, that in this one the wrench head will come off first.
Note that the actual worm screw /thumbwheel is about 2mm smaller than it needs to be for a nice fit, thus moving about with the jaw when it is not locked on a bolt.
As an emergency tool it should work, though it is obviously not designed for hard work.
I usually use Bahco, but I also have some cheap adjustable wrenches that I hand selected, making sure they had no play or slack. -
-
Well that is indeed a POS design flaw dks. ::) How could anyone screw this up so badly?
These wrench/knife tools have been around for almost 100 years, made by numerous firms from numerous different countries, and they are always made the same way, because the design cannot be improved upon: Make The Wrench Head Integral With A Full-Handle-Length LinerWhat part of that didn't those rough rider idiots understand?


-
-
-
-
-
-
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login

You've got the only one with solid brass ::) pins holding the wrench head on! 