5-Year Anniversary Gift Project
-
Today is my wife and I's 5 year wedding anniversary, and for the past few weeks I've been working an a little gift project that I thought you guys might like to see.
I had seen online (like here) where people make rings out of old silver coins. I thought it was cool and decided to give it a try.
After about 6 hours total effort spread across a few weeks, the ring in the attached pics was the result. I used a silver 1964 quarter.
I decided not to highly polish it like the one in the link as I like the hammered look.



-
I've started to make another one, this time out of a half dollar for a men's size ring.
Sorry for the poor picture quality. It is dark and overcast here this morning...



-
Awesome!

Happy anniversary!

***edit: I checked also your link, but couldn't get how exactly they make the very first stage / first picture

-
That is pretty cool. Happy anniversary!
-
Thanks guys!

-
That looks great..
Happy aniversary!!

-
Awesome, Happy anniversary,
If you can share more details how you made it will be appreaciated..
-
Thanks again everyone!

To make it, I used the steel block shown in the second set of pics as an anvil. You hold the coin and tap it on the edge with the ball pein part of the hammer. Then, rotate the coin a little and tap it again. Keep rotating the coin while constantly tapping it, and the metal will start to mushroom out as the diameter decreases.
Once it has reached close to the desired diameter for the ring size you are going for, you have to drill out the center. I found many different ways of doing it online so here is my method: I use a set of vise-grips with the round, crescent-shaped jaws and line the jaws with a thick piece of leather from an old belt. I tighten the vice grips just enough to secure the coin, but not too much pressure to bend it (especially important once a hole is in the middle, not as structurally stable).
I then use a normal drill bit to drill a large enough hole to fit a dremel sanding drum inside it. You have to be very careful here so that the drill bit doesn't catch and spin the coin loose as it could damage it. Once you can get a dremel sanding drum in, it is pretty easy from that point.
I found the sanding drums work better than the metal grinding bits they have. The metal grinders, when spinning fast enough to not stall out, get so hot that the silver basically melts into the crevasses, clogging them up. The sanding drums don't do this as bad.
Once it is sized right using the dremel, I finished by lightly polishing it using 0000 steel wool. I didn't want to remove the hammer marks, so I didn't use polishing compound like they do in the link above.
Thats all there is to it. Really a kind of fun, simple project.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login