Going about a mod
-
I'm still working up the courage to take a couple multis apart.
I usually take a bunch of pictures before tearing something new apart. They come in really handy once you forget where everything was.
Good luck and post some pix as you go if you get a chance.
-
Scibeer, if your amazing at taking apart SAKs then I'm sure you can take apart a MT! :D
-
First question is, how many points are there on the torx fasteners holding your Charge and your Wave together? Leatherman started off using 5-point security torx, and its not easy to obtain bits. A couple years ago they switched to 6-point security torx, bits for which are readily available. Which kind does yours have?
-
My Charge and Wave both have 6 pointed bits, I made sure to check that out too!
-
@E. Danny said:
My Charge and Wave both have 6 pointed bits, I made sure to check that out too!Cool! I've seen the 6-point security bits all over, including the local hardware store. :)
Don't be too concerned about messing anything up. Follow Bill's advice and take pictures before beginning. There are indeed a lot of washers and parts but you are only dealing with one handle in each tool. (Is that right, you can do the swap you want by only disassembling one pivot point in each tool?)
-
ya, i only gotta disassemble the one handle on both tools. just a real simple mod of switching tools out.
-
You should have no problems then. For reference, here's a Charge ALX totally disassembled (picture posted previously).

Only thing to be careful of is sorta hard to explain. The pivot screw you will be removing is actually two pieces, obviously. One side is a screw, the other side is a hollow threaded post. The post has flats on it that engage flats on the handle frame and the little washers, preventing tool "clumping".
Using your security torx bits, you want to hold the "post" side stationary while rotating only the "screw" side.
(Does that make any sense?) :P
-
So my charge has the round screws with the ridges on the outside like a quarter. I know the wrench for it must be hard to get a hold of.
So, dremel some slots and use a flat screwdriver, or make a quicksteel mold?? Channel locks will just make it ugly I'm sure.
I don't even want to change anything really, just rip the sucker apart!
These metal inserts on the handles have to go to. I have the slvr version from Costco.
-
Try ordering a couple of Kick pocket clips- they work as wrenches to loosen the knurled LM screws.
Def
-
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login

