New Guy - My Mods
-
GREAT work mate 8), thanks for sharing

I do like Vic's scissors BUT the spring on them
, I wish they had a more sturdy spring 
-
Nice work there

-
I like the idea of replacing the lanyard ring with an awl.

-
Nice ideas.... might have to attack my Fuse with the sandpaper now >:D
-
very nice work!
although I'm surprised you haven't received any suggestions yet to swap the TTi plier head for a Rebar plier head... so in that case, allow me to be the first. :Dyour Fuse looks nice too. I have a kick with a broken small flat driver, but I think there's enough of it left to make an awl similar to yours... might have to give that a shot!
-
Very nice mods:))
Sent from my SAMSUNG-SGH-I747 using Tapatalk 2
-
Thanks for the replies, all!
Hmmm... Rebar head. It has replaceable wire cutters and is a little more beefy, correct? Does it fit just as well, or do I have to make any other adjustments?
-
Since you already took out the scissors, it should be a relatively simple mod. Breezy dropped one right into an Charge XTi a while back with no other modification. The only thing I'm not sure about is the awl. However, since it looks like it was made from one of the flat drivers, it should be fine.
Long story short, it looks like it should just be a drop in mod on your Charge.

Mods look great, I like the SAK scissors. Might have to look into something similar on mine.

-
@Halligan Man said:
Thanks for the replies, all!Hmmm... Rebar head. It has replaceable wire cutters and is a little more beefy, correct? Does it fit just as well, or do I have to make any other adjustments?
Yes, the Rebar plier head has replaceable wire cutters that are made of 154CM steel, and I think "a little more beefy" is an accurate description. :)
like Delta said, with the tool layout shown in your picture, the plier swap should just be a drop-in. I don't think any other modification will be needed.
-
What about the locking tabs? Won't they get in the way when closing the pliers?
-
inside the handles there is a piece of steel riveted that is pushed out to lock the blades from opening once the pliers are deployed. At the bottom of it, next to the rivet there is a tab sticking out. I think I remember reading that had to be broken off to allow for the Rebar/ST300 pliers to fit.
-
@enki_ck said:
inside the handles there is a piece of steel riveted that is pushed out to lock the blades from opening once the pliers are deployed. At the bottom of it, next to the rivet there is a tab sticking out. I think I remember reading that had to be broken off to allow for the Rebar/ST300 pliers to fit.Ah, I see what you mean now. :)
breaking off that tab is only necessary if you're putting ST300 pliers into a Surge. the Rebar pliers play nicely with the tabs inside the Wave/Charge handles.

that being said, occasionally there is an issue with the pin sticking out too far and not allowing the blades to open even when the tool is completely closed. I have had to grind down a those pins ever so slightly on a couple mods, but I've had others where the pins worked perfectly with the Rebar plier head in place.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login

