Knife re-handling project.
-
Night mate :) I'll try working on my bitter twisted outlook on life ;)
-
Well went out to get some sandpaper today, and been practising going through the grits to get a decent finish. Hopefully this bar (had it lying around from a previous project) will fit in the holes in the handle, if not i'll have to get some more :( Taken this up to 400grit but still have 600 left, don't want to waste it though :)
Think it came up quite well, i'm more confident about doing all the sanding now though :)

-
Looks good to me mate, I'd just use some files to get a rough shape then sand it off :)
-
Wood arrived today :D Started to sand down the inside face flat so they sit against the blade nicely. Pics below
The blanks as they arrived:

My flat sanding "jig":

One blank done, one to go:

-
Looking good mate :)
-
Cheers :) just a shame you won't see that bit once its all together!! Well not directly anyway, if it wasn't flat you'd see the effects....
-
This is true :) Can't wait for the rest of the bits to arrive so i can see what its actually gonna look like!!
-
Oh so nothing too vital then :D
-
Nah not at all :D
-
Haven't decided yet, i'll see how the knife goes then think about the sheath.
-
here's a tip I found for a guide for your slabs/scales when your first setting them ;
Clamp a "file" guide onto your knife blank at the ricasso. Use this file guide to line up that perfectly squared end
of the handle scales to exactly where you want it. If you're using a guard, do it first, before doing the handle scales.
Put the guard (if your using one) against the file guide. Once the two guards are on the scale, you can take the
file guide off and use the back ends of the guard (again if your using one) for your guide for the handle scales.after you've epoxied and set them on with pins and they are cured completely, you can take off the file guide.
The fronts of your handle scales will be perfectly aligned every time,using this method! -
you may already now this but I thought it was a very interesting "temp jig" instead of "eye-balling"
or guessing exactly where they should be in case they move while setting them on and during curing :)
I have a whole page I saved for doing this, that's just a part. -
Sounds interesting, you got a link to that page per chance? :)
A few more pics of the second blanks transmogrification:



-
unfortunately not, it was a thread (somewhere, probably BF) and I just copied
several posts/tips, I can give you the whole thing in a private if you want!and them scales are coming out nice!
-
Cheers WD :) (both for the comments and the pm ;) )
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login