crackout's Adventures in Alox.
-
You tease, get the hammer.

:D
-
We have liftoff. I give you: the overly attached Executive. :D



-
-
A+ I Dont see any dings in the scales.

-
Oh me wants! No pocket clip for me thanks. It is the devil finding an alox exec.
Wow, I need to get a stateside guy to fab one up.
Cheers
-
Very, very nice mate.

-
Crackout!
-
I just ordered 3.0mm and 2.5mm carbide bits to finally attempt my 111 mod.

-
Built a new Urban Pioneer with my remaining anodized scales. Golden screws.

Oh and I made new pivots for this one using pin stock with a 1.7mm hole I cut a M2 threading in.
I can make custom lenghts now. Up to 100cm. :D -
That is rather big news!
-
Brass.
I made a test where I clamped a piece in my vice and went Rambo on it. It withstood a lot of pressure.
So I'm pretty sure these will hold beautifully in EDC.Side note: I also clamped the modified Solo spring (with a rest for the scissors) in the vice as well and gave it a few blows bending it a few degrees. Now the scissors have amazing snap. The difference is huge. I'd suggest this to anyone using Solo or blade springs for scissors.
-
I have - In the same spiirit - bought soem 4 mm Brass tubeing with 2 mm id to tap M3 threads in tehre and be able to screw togetehr soem 108 and 111 mods. 4 mm Carbide bits are easier to come by than imperial sizes and there is enough meat left at the pivots.
I´m looking forward to your experiences and will gladly share mine!
-
@lowtech said:
I have - In the same spiirit - bought soem 4 mm Brass tubeing with 2 mm id to tap M3 threads in tehre and be able to screw togetehr soem 108 and 111 mods. 4 mm Carbide bits are easier to come by than imperial sizes and there is enough meat left at the pivots.I´m looking forward to your experiences and will gladly share mine!
Thats a good idea, larger pivot should be strong enough.
I bought some stainless 4mm rod to make some swisstool spirit pivots with so I dont have to drill out those tools to replace with pivots and be able to easily add pocket clips.
-
@crackout said:
Side note: I also clamped the modified Solo spring (with a rest for the scissors) in the vice as well and gave it a few blows bending it a few degrees. Now the scissors have amazing snap. The difference is huge. I'd suggest this to anyone using Solo or blade springs for scissors.I found that works well,
even with just careful shaping of the "ramp" at the free end of the backspring and a slight bend you can get scissors sitting just right and having really good snap on a Solo spring.
The main thing is to go SLOWLY with the filing/dremelling and test fit often... you can't put material back. :) -

Finished! I love these.
-
Nice!
sent from Nate's mobile
-
Very nice. :)
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login
