Polishing SAK Cellidor Scales.
-
+1 for Brasso

-
Amici,
Dittos on Brasso, and thanks for the link and the heads up on the plastic polish!Cheers,
Serge -
These are great too: http://www.leevalley.com/en/wood/page.aspx?p=62127&cat=1,250,43243,43245
-
Here is one before and after set. Afraid its the only one that i had the fore-thought to take a before photo of.
It came out really well, still need to get some of the white paste to rub into the lettering.
Does anyone know what is normally used? These are embossed letters. -
The polished scales look beautiful!

-
Nice job!
For the skinflints among us, toothpaste does a good job and makes your SAK minty fresh.
-
Hate to resurrect an old thread but thought to add a useful tip, or at least what worked for me. Did not do much research before polishing my two celidor "basketcase worn" saks the other day so used what was handy -
Applied Meguiar's "All Metal Polysh" to an old leather belt/strop and polished/rubbed the knife on it without removing the scales. This took out most if not all of the deep scratches and now those old and very worn celidors shine like new. Mirror finishing could be done with a microfiber towel with or without the polishing compound.
I suppose a felt wheel on a Dremel and a little polishing compound would work wonders even faster.
-
@borgwarrior said:
Do you have and before/after pics?Pretty much what I was thinking...
-
I renovate a lot of really trashed knives frequently. Many have pretty deep gouges as well as pocket wear (or worse).
To fill really deep gouges I use two part Epoxy, let it set overnight, then 400/600/800/1500 wet and dry, all with lots of water. Finally buff the scales with Simichrome on a soft cloth. They get to a (usually) even better than factory finish, meaning they have a deep, burnished, highly polished look to them.
No real need to remove the scales, though it can be a little easier if they are removed. -
For those not afraid to buy some ladies' items, a nail buffing block will take out a lot of surface scratches from cellidor scales :D
-
I use Mother's Mag wheel polish on just about everything from SAK scales to the chrome bumper of a 1969 Chevy truck. I have bought many user knives on eBay and brought them back to life with the stuff.
-
The BEST... end of story.
-
Oh that plastic restoration stuff tickles my fancy! Have some headlight restoration stuff at shop, suppose it is similar to this. Will get, thank you!
-
In my early days as a collector, tried various products, Solvolautosol etc.
Yes , even Brasso works. Hours of fun !!
However, unless sentimentally attached to the old scales, and their associated 'battle scars', it is far easier to scrap the damaged ones, and replace with new scales !! -
Amici,
I had to bump this thread from the ether since on a whim, I recently picked up a Novus Plastic Polish kit for a great price and I wanted to see what it could do. Sure we all know the Victorinox secret regarding scales by now that they're replaceable so who cares if they get dinged up, just replace them!!But for those one of a kind cases where you don't want to, this product really does the trick. I recently acquired another NOS Ranger with flouted corkscrew as well as those nice solid Cellidor scales. Well they were a little dinged up. So instead of popping off and replacing with a pair of nice, but hollowed out Cellidor, I decided to give this product a try.
Well it worked remarkably well! So if you're in the market to refurbish a set of old scales, the Novus Plastic Polish kit will definitely do the job..
Cheers,
Serge -
One issue I've been having woth the polishing compound I'm using is that it splatters everywhere when I use the dremel tool with polishing ball.
Is the Novus stuff more of a paste than a liquid? I'd like to try something thicker that makes less of a mess.
The stuff I use works well, but I have to do it inside a cardboard box to avoid splatter all over the workbench.
-
Amici,
The Novus polish is a cream or a paste if you will that comes in 2 different consistencies. Number 3 is coarse for those scales that are really dinged up, and number 2 is of the fine type meant as a finisher, or for scales that need a bit of tweaking as you were..I simply apply a small amount with a cotton ball, and use circular motions. Follow up using the same method with number 2, and then buffing to a nice sheen. It really is quite remarkable, how nice they turn out..
Cheers,
Serge -
A bit of a necro thread, but one worth reviving, I think.
Like the OP, I've used Novus plastic cleaner/scratch remover to clean up a few celidor scales in the past. However I'd never tried to polish translucent scales. Today I pulled out a translucent blue Tinker and attempted to clean up some fairly rough scales.....
Before, shield side:

This side has some scratches and one spot, almost right on the shield, where I grabbed the SAK while I had some acetone on my fingers. Instant melt!
Before, driver side:

Again, some scratches and an acetone melt spot. Ooooops.
The spa regimen:

I went in order of 3-2-1. Seemed only smart.
After, shield side:

Much better! This was accomplished in less than 5 minutes. The acetone thumb print is still fairly prominent, but overall a nice improvement. I think if I want to remove that thumb [rint some automotive sandpaper might be called for.
After, driver side:

Again, much better! I suspect that with a bit more time and effort, this could be made even sharper, but I was satisfied with the results.
Overall, I was really please to see the scale 1) NOT turn some cloudy, opaque color, and 2) some significant scratches get cleaned up easily. I'm giving these Novus products two big thumbs up.

For those of you who might have a hard time finding Novus. I got this product and a motorcycle dealer's shop. It was recommended for taking scratches out of windscreens and even face shields. So if Novus isn't available, you might try looking for a plastic polish at a place that sells helmets or plastic windscreens.
Now....sandpaper that acetone melt spot out....or leave it be......

-
@Nix said:
A bit of a necro thread, but one worth reviving, I think.Like the OP, I've used Novus plastic cleaner/scratch remover to clean up a few celidor scales in the past. However I'd never tried to polish translucent scales. Today I pulled out a translucent blue Tinker and attempted to clean up some fairly rough scales.....
Before, shield side:

This side has some scratches and one spot, almost right on the shield, where I grabbed the SAK while I had some acetone on my fingers. Instant melt!
Before, driver side:

Again, some scratches and an acetone melt spot. Ooooops.
The spa regimen:

I went in order of 3-2-1. Seemed only smart.
After, shield side:

Much better! This was accomplished in less than 5 minutes. The acetone thumb print is still fairly prominent, but overall a nice improvement. I think if I want to remove that thumb [rint some automotive sandpaper might be called for.
After, driver side:

Again, much better! I suspect that with a bit more time and effort, this could be made even sharper, but I was satisfied with the results.
Overall, I was really please to see the scale 1) NOT turn some cloudy, opaque color, and 2) some significant scratches get cleaned up easily. I'm giving these Novus products two big thumbs up.

For those of you who might have a hard time finding Novus. I got this product and a motorcycle dealer's shop. It was recommended for taking scratches out of windscreens and even face shields. So if Novus isn't available, you might try looking for a plastic polish at a place that sells helmets or plastic windscreens.
Now....sandpaper that acetone melt spot out....or leave it be......

That's a great job

I use 6 way nail buffer pads for that myself..., they do a great job and are dirt cheap. Like "budget" micromesh pads, up to very fine grits for great polish and shine



-
I'll keep my eyes open for those!

Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login

