Which bit extender should I get?
-
I think I'm right in saying that the tool adapter (your second picture) is made to fit the earlier LM variants, this would include PST I and PST II, Sideclip and earlier versions of the Supertool, but not the Surge. See that small metal lug on the tool adapter? It fits under the handles these earlier LM multis but it may not be possible to close the Surge handles over it.
So for those reasons I'd go with the bit extender, but I'm sure one of my more learned friends on here will put us right if I've got that wrong.
-
If you are like me, only plan to extend the reach of screw driver, you can just use this. Cheaper and easier to carry.

-
i didn't realize the bottom kit fitted the surge??? what other tools does it fit?
-
Could it be that there are two versions of the universal adapter?
Here it looks different (simpler) in the photos and says it fits the surge
-
Go for the top one. You can use 1/4 bits and the flat bits.
that's us mobile
-
The bottom one gives you a 1/4 option but the top one extends a lot. In short go for the top one
-
There are 2 versions of the universal adaptor, one has the little metal piece and one does not. The one that does not will fit the wave and the surge, if you end up with one with the metal piece it is easily ground off, thats what I did.
Sent from my SCH-I605 using Tapatalk
-
I went with the 1st one and love it. It really works well and if you have 1/4 bits it will easily accept those. I was going to grind an extender down but this isnt expensive IMO so grab one. Thin and easy to carry in the LM sheath.
-
The one that does not will fit the wave and the surge,
Really? I wonder if it would work with the Rebar.
Nothing does lol
-
The one with the tab is actually the (original) Tool Adapter; check this out. The one without the tab is the Universal Tool Adapter, and it's as universal as it gets...







(... and the list goes on...)
-
You want the top one. The bit extender! :)
-
If you are going to put a lot of force into anything (and you do have the heavy duty Surge, right ?) then IMO the universal tool adapter is much stronger (have a look at the thickness of the metal in the Surge bit holder and at the bottom of the bit extender and you'll see what I mean). Also the universal tool adapter works well with std 1/4 bits, the bit extender is a bit deep.
-
I use the top one, the bit extender, with my Surge. Works well. If I ever feel I'm over stressing it, I can usually go and grab a dedicated driver or more appropriate tool.
-
The one that does not will fit the wave and the surge,
Really? I wonder if it would work with the Rebar.
Nothing does lol
This is the one that fits the rebar

Its called the removable bit driver
http://www.leatherman.com/931012.htmlSent from my SCH-I605 using Tapatalk
-
I was wrong.
-
After you get the extender sorted then you'll need a ratcheting driver for it ;)

Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login


