What did you use your Leatherman for today?
-
-
My desk fan at work seized yesterday. The motor was still working, but the shaft had seized. So, Blast to the rescue. I stripped the motor down, cleaned everything and re-lubed it so the shaft could spin freely again. Works as good as ever now.
I'll probably have to take it apart and re-lube with grease at some stage as I'm just using oil as it's all I had on hand, but it works for now.



-
Used my juice s2 too cut some 6mm rope....and broke the blades back spring
Sent from my iPad using Tapatalk
-
@Sparkydave said:
Used my juice s2 too cut some 6mm rope....and broke the blades back springSent from my iPad using Tapatalk
Another one bites the dust

-
The little bar actually snapped
Sent from my iPad using Tapatalk
-
@Sparkydave said:
The little bar actually snappedSent from my iPad using Tapatalk
This seems to be an epidemic with the Juice.
-
launch time at the office today....

-
-
@Monrogue said:
I used the file on my BORebar to cut a fork in half for some kind of craft project my wife was going to try. I guess it was to make the handle end into a ring somehow. I used the Supertool's file to smoothen the cut end of the handle as the Rebar's seemed to be too coarse for that task.It's nice to see them earning their keep :D
-
I used the file on my BORebar to cut a fork in half for some kind of craft project my wife was going to try. I guess it was to make the handle end into a ring somehow. I used the Supertool's file to smoothen the cut end of the handle as the Rebar's seemed to be too coarse for that task.
It's nice to see them earning their keep :D
It is

-
Used the Piranha II to pry up some nailed down wooden bits on a roll top desk I'm refinishing [worked great]. When a nail popped through the wooden piece, I tried the MUT foot [i.e. hammer, but in reverse - get it? ;)] on the nail. I don't know my nails that well technically, but a kind of finishing nail but with a flat head. Anyway, MUT popped the head off. When I couldn't pull the remnant out with MUT pliers [tough bugger], Surge came through with newww blade exchanger holding a hacksaw.
Aaand...used the MUT hammer to close the louvers on the attic fan. They never close now, once the fan is turned off. Probably because I haven't WD-40'd them. But if I did - then I'd never use the MUT for that purpose again, would I?? :D
-
First use of the scissors on my modified Kick to cut out the Amazon returns label.

-
-
Used my sideclip today to remove a sticker and the cast on my left arm. Why pay the doctor to do it. >:D
-
ST300 to hang a picture.
-
Used an Original Supertool to disassemble a desk and bookshelf, and then reassemble the same after moving to a new office.
-
My kid just borrowed the Surge to open a packet of noodles. Kids these days. ::)
-
After hitting my thumb twice while driving some small wire nails into a book case I was building, I used the pliers on my PST to hold the nails while starting them. It worked out quite well. tom.

Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login


