What did you use your Leatherman for today?
-
@Sparkydave said:
The little bar actually snappedSent from my iPad using Tapatalk
This seems to be an epidemic with the Juice.
-
launch time at the office today....

-
-
@Monrogue said:
I used the file on my BORebar to cut a fork in half for some kind of craft project my wife was going to try. I guess it was to make the handle end into a ring somehow. I used the Supertool's file to smoothen the cut end of the handle as the Rebar's seemed to be too coarse for that task.It's nice to see them earning their keep :D
-
I used the file on my BORebar to cut a fork in half for some kind of craft project my wife was going to try. I guess it was to make the handle end into a ring somehow. I used the Supertool's file to smoothen the cut end of the handle as the Rebar's seemed to be too coarse for that task.
It's nice to see them earning their keep :D
It is

-
Used the Piranha II to pry up some nailed down wooden bits on a roll top desk I'm refinishing [worked great]. When a nail popped through the wooden piece, I tried the MUT foot [i.e. hammer, but in reverse - get it? ;)] on the nail. I don't know my nails that well technically, but a kind of finishing nail but with a flat head. Anyway, MUT popped the head off. When I couldn't pull the remnant out with MUT pliers [tough bugger], Surge came through with newww blade exchanger holding a hacksaw.
Aaand...used the MUT hammer to close the louvers on the attic fan. They never close now, once the fan is turned off. Probably because I haven't WD-40'd them. But if I did - then I'd never use the MUT for that purpose again, would I?? :D
-
First use of the scissors on my modified Kick to cut out the Amazon returns label.

-
-
Used my sideclip today to remove a sticker and the cast on my left arm. Why pay the doctor to do it. >:D
-
ST300 to hang a picture.
-
Used an Original Supertool to disassemble a desk and bookshelf, and then reassemble the same after moving to a new office.
-
My kid just borrowed the Surge to open a packet of noodles. Kids these days. ::)
-
After hitting my thumb twice while driving some small wire nails into a book case I was building, I used the pliers on my PST to hold the nails while starting them. It worked out quite well. tom.

-
I'm growing to like the PST2 more and more.
One of the computers had work had the wireless card crap out on it so I've removed that and as a workaround made a network cable using the PST and cat5 crimpers.
The serrations on the blade were perfect for resting the cable on and turning to trim off the outer cover. The scissors trimmed the excess fibre stuff to get that out of the way, and the wire cutters trimmed everything to length.

-
Used the Micra to nub a Punch Rare Corojo while I smoked it at the shop
Sent from Terry's Texting Tool

-
@stealth007s said:
Used the Micra to nub a Punch Rare Corojo while I smoked it at the shopSomehow, that just doesn't seem fair. Aside from the fact that I think I can smell that from here...which then remindeth me that I haven't had a cigar in almost two years! Wow; how the hell did that happen?? ::) You give me an idea. Now - if I could combine it with a Leatherman somehow...and a showgirl...hmmmm...

-
@zoidberg said:
My kid just borrowed the Surge to open a packet of noodles. Kids these days. ::):D If your child is using a Surge, then he's going to be OK...

I used my Crunch [good grief; what a great tool] minimally, but to some effect. That is, in replacing the bathroom double sink, it held the broken SS brush as I attempted [over and over] to clean the pipe threads. If logistics had allowed, I absolutely would have used the Crunch for everything. Alas, it took some serious mother plumbing tools to get the previous fittings off [read: straddling the cabinetry to get one of the bugger's off] at the pipe. Used the Surge to trim off excess around the pipes where they meet the wall. Oh, and earlier, used the MUT to hammer the drain plug control [whatever...] out.
Beer never tastes as good as when you've used your Leatherman tools as much as humanly possible. Which - OK - today wasn't exactly THAT - nevertheless, my previous statement stands. :P

-
Used my ST300 to fix my kitchen doorlock. I was in shover and my kids might have been hassling with the lock. Lock jammed, and nearly left me the other side of the house.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login

