Anybody worked with plastics
-
Last week I noticed the filler cap cover on her car was open - closer inspection revealed that the plastic clips that allowed the cap to open and close was broken. After checking online what it actually was I found that no one could actually get one.
So, I made one using a heat gun and some scraps of plastic. Took a few attempts to get it right but sorted it in the end.
I actually quite enjoyed it. Which brings me to my question.
A few years ago when I was working as a shop fitter I grabbed a load of acrylic/perspex that was headed for the skip. My original intention was to use it for making router jigs.However, I'm now curious as to what I can come up with. Can anyone recommend a good source of advice for a complete beginner into how to form/polish/adhere these materials.
Any suggestions at all would be gratefully appreciated.
-
I thought about doing that, and when I started researching what it would take I found out it is actually a lot of work
-
I don't have much experience working with Acrylic, but while researching for how to work with kydex, I did come across these channels and the presenters seems to know how to work with Acrylic.
ePlastic
https://www.youtube.com/user/ePlasticsTV/videosSerroxAcryl
https://www.youtube.com/user/SerroxAcryl/videosTAP Plastic
https://www.youtube.com/user/tapplastics/videos -
I know a guy who repaired a couple of cracks in a plastic bumper bar with a piece of plastic and a soldering iron, it turned out pretty good after some filing/ sanding/ painting etc.
-
From what I remember of my model making course at Uni working with acrylic and perspex is fairly straightforward. It cuts and sands easily, though you need to be thorough if you want a polished finish. You can bend acrylic fairly easily with some heat though it's difficult to do straight lines without jigs and formers, and a method of localising the heat input. There were some special, very thin solvent adhesives that we used to join it - brush it on and it wicks into the joints.
I've also used ABS - that's even easier than acrylic to use, but not as stiff. It cuts and drills really nicely. We use it for all sorts of low-stress jigs and fixtures at work.
Suggest you get down to your local model railway shop - it's the sort of stuff these guys do all the time for building scenery.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login