Problem
-
Keep open/close the blades under running warm tap water.
-
I wonder if it hurt it to boil it in some water.
-
soak it in goo gone? maybe?

-
@ducktapehero said:
I wonder if it hurt it to boil it in some water.Shouldn't.
-
Maybe a run through the dishwasher...either that or a high pressure water hose into the parts that are crunching while you move the blades back and forth.
-
@Corrugated said:
Maybe a run through the dishwasher...either that or a high pressure water hose into the parts that are crunching while you move the blades back and forth.+1

BTW welcome phil

-
Perhaps something like this? http://www.lakeland.co.uk/sticky-stuff-remover/F/product/8976
I've never used it on a tool but it certainly works in other applications.
-
@noth said:
Hi there mate, welcome to the forums.
what get me in trouble the most is the corkscrew...... :D
A corkscrew on a swisstool? Do you by any chance mean swiss army knife? I'm not sure how would cellidor react to boiling...
I assumed it was the corkscrew attachment on the Swisstool, but good call to check before those scales go all bendy.
-
mineral spirits might loosen the gunk up...soak/shake
-
@ducktapehero said:
I wonder if it hurt it to boil it in some water.That sounds just crazy enough to work

Then zap it with WD-40 afterwards

-
Gas? I know its harsh but shouldnt be too bad on the finish. Then soak in some detergent and lightly oil
-
Do you have a Ultrasonic jewelry cleaner? Those things do wonder. Just let it soak in a water bath and give it a few cleaning cycles. I bet that would work out the gunk in no time.
-
@phil said:
yes, a day in the water and 4 hours in oil......
i think i willl try again.
thanksHot water is an OK solvent.
However, since hot water isn't working I'd go straight to a more righteous solvent - acetone!
Acetone won't hurt the stainless steel, but it should dissolve the organic crud that's gunking up your multi.
(If you don't have acetone around and don't want to buy it, try turpentine or even gasoline. Be careful - all of these solvents are highly flammable and give off toxic vapors.)
.
-
welcome to the MT Forum phil

even the French have better smelling tools! :D
good luck

-
I know this is rough but I use it at work if you can try useing some MEK be very carefull with it thought alot of ventilation and even a mask if you can then wash with a bunch of hot water and then use some liquid wrench and keep working the tools as the liquid wrench dries.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login