Question about getting my Swisstool cleaned/fixed.
-
I have a Swisstool which I carry everyday. The best multitool I have ever used, but lately a couple of the tools pull out along with the one I actually want out. Could that just be because of dirt/grease in the tool?.
If so would dunking it in warm soapy water and scrubbing it down take care of that?. And if I do that how do I dry the whole thing out so I dont have to worry about rust. I dont have a blow dryer or access to an air blower, and a rag wont get down inside there very well.
Also when I try to use the ruler it is supposed to stay in position, but for some reason it flops down and I have to hold the handles out to keep them straight while I measure something. What would cause that to happen?.
-
The anti corrosion/oxidation properties of Victorinox's steel is high. With all the things you have to worry about rust really isn't one of them. As long as you don't dunk it in salt water or anything acidic your fine.
As far as warm soapy water, yeah that's your best bet. Work the tools while it's submerged then finish off with your preferred oil. I use 3 in 1. I brush oil on, I no longer apply oil drops. Just leaves oil down in between the tang and liners with no real purpose other than collecting dirt and debris.
If this doesn't work, WD-40 it over night and repeat the cleaning process.
-
Indeed, a good cleaning will do it well. I just leave my Vics drying near an open window and it works well. I personally just use a little of the Victorinox oil on my Swisstool Spirit.
-
I actually once dried an MT in the oven...
So if you want to be sure it's dry, you could try that ;) -
I always put my SAKs into the Dish-washer.
-
@bmot said:
I actually once dried an MT in the oven...
So if you want to be sure it's dry, you could try that ;)I've done that loads of times, better still - whilst its hot spray it with WD40.
I bought a tti cheap, in a real bad state. Scrubbed it clean with hot soapy water and scotch brites, dried it completely in the oven for 40min, then removed it and soaked it while it was still hot with WD40.
It looks amazing!!! -
I'll echo giving the swisstool a good warm or even hot water bath and moving the implements while doing this. dry off as best you can and spray with wd40 and you should be good to go. I follow up with a good lubricant. I got 3 pretty well used swisstools and they all got the same treatment and were in great condition afterwards.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login