leatherman bit extender question
-
got a new Wave and the bit extender for Christmas. So after playing with it for awhile, I'm thinking, didn't I read somewhere that it'll take (the extender) regular 1/4" bits as well?.........and so I pop one in and. it goes way in past the little retainer ring and gets stuck. Won't come out even with a 4" vice grips on it. So I take it out to my little shop and put the extender in the vice, and put a bigger vice grips on the bit, but nothin' doin'. Eventually, I manage to snap off the tip of the bit, which happened to be a very small phillips, and so now there's nothing to grab onto. Last resort, I use a utility knife and successfully remove the retainer ring, and the bit comes right out. Got it back in and so it works fine again, although I won't be trying any regular 1/4" bits in the near future. I still thought I read where they'd work, but I guess not. Any thoughts on my near disaster? thanks, and Merry Christmas to all.
-
@tonyg said:
got a new Wave and the bit extender for Christmas. So after playing with it for awhile, I'm thinking, didn't I read somewhere that it'll take regular 1/4" bits as well?.........and so I pop one in and. it goes way in past the little retainer ring and gets stuck. Won't come out even with a 4" vice grips on it. So I take it out to my little shop and put the extender in the vice, and put a bigger vice grips on the bit, but nothin' doin'. Eventually, I manage to snap off the tip of the bit, which happened to be a very small phillips, and so now there's nothing to grab onto. Last resort, I use a utility knife and successfully remove the retainer ring, and the bit comes right out. Got it back in and so it works fine again, although I won't be trying any regular 1/4" bits in the near future. I still thought I read where they'd work, but I guess not. Any thoughts on my near disaster? thanks, and Merry Christmas to all.It does say that it works with all standard 1/4 inch bits. Here is screenshot from their website. Contact them you may have a defective spring clip. Maybe try a different 1/4 bit, maybe it is your bit???

Sent from my SM-G935P using Tapatalk
-
It does work with regular bits, but they go in deep like you experienced. Yours must be a bit stiffer than mine because I can get bits out usually by giving them a wiggle. A cheap way to stop them sitting low is to pop a rubber or cardboard disc in the bottom ( or something similar). Alternatively if you don't want to do that you can just buy a long bit bit set.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login