Dullish blade. How to sharpen it and not ruin the edge?
-
You can also start by taking a permanent marker and mark each side where you'll be sharpening. As you start to sharpen, the marker will tell you whether your angle is too high or low compared to original. It takes practice, don't be afraid to mess up. I practiced many moons ago on a cheap paring knife. Hold the blade vertical (90 deg.), Half of that is 45 deg. Half of that is 22.5 etc. You'll develop an eye/feel for the angle.
-
@WolfyW said:
You can also start by taking a permanent marker and mark each side where you'll be sharpening. As you start to sharpen, the marker will tell you whether your angle is too high or low compared to original. It takes practice, don't be afraid to mess up. I practiced many moons ago on a cheap paring knife. Hold the blade vertical (90 deg.), Half of that is 45 deg. Half of that is 22.5 etc. You'll develop an eye/feel for the angle.This......

-
Good advice above already
Good luck on your sharpening endeavor

-
@WolfyW said:
You can also start by taking a permanent marker and mark each side where you'll be sharpening. As you start to sharpen, the marker will tell you whether your angle is too high or low compared to original. It takes practice, don't be afraid to mess up. I practiced many moons ago on a cheap paring knife. Hold the blade vertical (90 deg.), Half of that is 45 deg. Half of that is 22.5 etc. You'll develop an eye/feel for the angle.This is good advise. If you need more try google search for instinctive knife sharpening. It's a video I dod a few years back on freehand sharpening. I'm the guy in the gray flat cap.
-
Thanks a lot people! All your tips will be very helpful! Thanks!
Sent from my iPhone using Tapatalk
-
All of the advice above are great. You are in good hands. Sometimes you just have to dive into it. And with a SAK you can always resharpen for corrections. Paper is your best friend to test for sharpness. I would just add that a dull edge will appear shiny so just stop once in a while and check that edge.
-
Okay, since nobody asked, I will. Why would you take a knife to a Locksmith??

-
Hah! Same in the Philippines. The guy would pedal on his bike to spin the sharpening stone.
-
You can also start by taking a permanent marker and mark each side where you'll be sharpening. As you start to sharpen, the marker will tell you whether your angle is too high or low compared to original. It takes practice, don't be afraid to mess up. I practiced many moons ago on a cheap paring knife. Hold the blade vertical (90 deg.), Half of that is 45 deg. Half of that is 22.5 etc. You'll develop an eye/feel for the angle.
This is good advise. If you need more try google search for instinctive knife sharpening. It's a video I dod a few years back on freehand sharpening. I'm the guy in the gray flat cap.
Spot on Wolfy

Nice little video CB


-
Okay, since nobody asked, I will. Why would you take a knife to a Locksmith??

Don't know about Brazil (where OP is from), but here in W-Europe, alot of locksmiths also repair shoes and sharpen knives/scissors. So it's not that strange. ;)
Exactly. I'm just afraid the guy will ruin the blade hahaha
Sent from my iPhone using Tapatalk
-
I wouldn't let some locksmith or other guy sharpen my knife. First, it's so easy to do with a SAK, second I've seen too many of these guys who over do it and do indeed damage the knife.
Any soup bowl or coffee mug with an unglazed ring on the bottom can sharpen a SAK. A stropping on the back of an old leather belt after will put a shaving edge on it. Learning to do it yourself will give you a sense of independence that is priceless. Any smooth stone out of a creek will do. The underside of the top of a toilet tank can be used. A piece of 500 grit sandpaper on a mousepad can be used. One thing you don't need is one of those over priced and over hyped sharpening gizmos that they sell, not to sharpen knives, but to get your money out of your wallet and into theirs.
-
Lansky 4 Rod Ceramic Turn Box Knife Sharpener is the easiest way to go for someone new at sharpening.
You'll have your choice of 2 diamond rods and 2 ceramic rods or 4 ceramic rods, depending on which model you choose.
Just hold the knife vertical and draw down wards.
-
This is what I use

If you want to be creative and save money just buy a small sharpening stone like the fallkniven DC4 and use an old leather belt for stropping. Also you can use the bottom of a coffee mug and then use a leather belt for stropping. On youtube you can find tips and howtos.
Sharpened the blade of my 1947 Soldier today. The shape of the blade isn't perfect but to make it look perfectly straight and free of chips I would have to remove too much of the blade.
It is shaving sharp though.

While I was busy I also sharpened the kitchen cutlery :D
-
@glenfiddich1983 said:
This is what I use
If you want to be creative and save money just buy a small sharpening stone like the fallkniven DC4 and use an old leather belt for stropping. Also you can use the bottom of a coffee mug and then use a leather belt for stropping. On youtube you can find tips and howtos.
Sharpened the blade of my 1947 Soldier today. The shape of the blade isn't perfect but to make it look perfectly straight and free of chips I would have to remove too much of the blade.
It is shaving sharp though.

While I was busy I also sharpened the kitchen cutlery :D
It's amazing how those things last... Heck it's almost as old as my grandfather and in better shape than he is
Sent from my iPhone using Tapatalk
-
In my opinion freehand sharpening is the way to go...it is a lifetime skill that should be cultivated. It might take a while to gain the muscle memory to hold proper angles, but it is worth the effort. Once learned, there is no need for special fixtures or jigs and you will be able to sharpen just about any edged tool...from axes to scissors...
The easiest method to start with is sandpaper sharpening. I do not like using a mousepad even for convex edges...I use a fairly stiff sheet of rubber glued to a board. There are plenty of instructions and videos on the web for sandpaper or mousepad sharpening.
Learn to keep your edges touched up between uses and it will be a long time before you actually need to sharpen.
-
@Spork, Lord of Lime Jello! said:
In my opinion freehand sharpening is the way to go...it is a lifetime skill that should be cultivated. It might take a while to gain the muscle memory to hold proper angles, but it is worth the effort. Once learned, there is no need for special fixtures or jigs and you will be able to sharpen just about any edged tool...from axes to scissors...But…then how will all those marketers of the special fixtures and jigs make money?????
And make no mistake, it's all about the money. People have been sharpening knives and swords since biblical days, with no special fixtures and gizmos. But the marketers have turned knife sharpening into some sort of mythical hyped procedure to intimidate the new comer into thinking it's more complicated than it really is. And they can sell some whiz bang gizmo to you. Think about this; some Roman legionnaire about to fight the Carthaginians, some Crusader camped outside Jerusalem in the third crusade, or some mountain man in the 1830's in the Rocky Mountains after beaver skins, didn't have anything but a smooth rock. Yet they did well with primitive stones. A little leather with some goose oil to strop it on and they were good to go.
Knife sharpening is easier than you think. If you can walk, you can sharpen on a stone.
-
@glenfiddich1983 said:
This is what I use
If you want to be creative and save money just buy a small sharpening stone like the fallkniven DC4 and use an old leather belt for stropping. Also you can use the bottom of a coffee mug and then use a leather belt for stropping. On youtube you can find tips and howtos.
Sharpened the blade of my 1947 Soldier today. The shape of the blade isn't perfect but to make it look perfectly straight and free of chips I would have to remove too much of the blade.
It is shaving sharp though.

While I was busy I also sharpened the kitchen cutlery :D
Nice knife, nice advice. One more thing, you can sharpen the blade on the DC4 or DC3 and then use the stones' pouch/sheath as a strop. Works like a charm

-
@BleaKrytE said:
That would indeed be perfect but the thing is: I got no money, plus parents don't like my SAK (yeah I'm a teenager) so buying a sharpener is a no go.Sent from my iPhone using Tapatalk
How 'bout ..............
Black sharpie marker - to color the edge so you can VISUALLY see what and where you are actually sharpening.
& the "Ol' Bottom of a Porcelain/Ceramic Coffee Cup Trick" :D ? link to many vids: https://www.youtube.com/results?search_query=coffee+cup+knife+sharpening
IF you dont have a whetstone of the correct courseness - there are some that are too course and will RUIN your blade(not all stone are the same or good for knives :) ) - the bottom of the cup if FINE in courseness.
-
Favorite knife sharpener;
<a href="https://flic.kr/p/gq2euJ" target="_blank" rel="noopener noreferrer"><img src="https://c7.staticflickr.com/8/7429/10117187934_a1b70bcc95_c.jpg" alt="banner" style="max-width: 100%; height: auto;" /></a>
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login