SAK Spring Questions
-
@comis said:
I don't know whether this will help, but do you think it is possible to make a hole on the outside liner, then peen a rivet spacer right under the flathead, then on the other side of the liner, just peen it as flat as possible and make minor changes to the scale?You're assuming I have a drill :D
I did this in the end, cut up a bike wheel spoke and super glued the pieces in. It's a drop high, I'm filing down the 'kick' of the bottle opener at present.

-
This is satisfying and I can't wait for the results! I really enjoy reading and seeing pics of people solving problems
[It's not failure if you learn something from it]
-
Here it goes folks. Just needs to be sharpened back up now. Oh and the custom scales I ordered for it haven't arrived yet, these are some old nylon scales for the moment.

3 layer, blades centre line, inline screwdriver. Pretty much my perfect urban SAK EDC.
I'm happy about most of it. The bottle opener sits a drop high but isn't uncomfortable in hand. The biggest 'problem' is the scissors layer. It doesn't sit well with the corkscrew which sits a bit proud but again not enough to dig into the hand. I didn't realise prior to dismantling but the hook creates the correct strain on the scissors spring to provide the snap. Without the hook it closes lazily unless the corkscrew is open. Again, not enough to be any problem in use. I'm sure someone with the skill set could modify the spring to fix both problems but I did the entire mod using the bottle opener on a 111mm, my LM Charge pliers/file and a hammer. Hardly high tech. :D
What will I do next time? I'd probably keep the blades where they belong (on the side) with the corkscrew and put the awl on the scissors layer. I'd also be a drop more careful with my spacer under the bottle opener for a more precise fit.
-
Nice work and Awsome mod!
[It's not failure if you learn something from it]
-
Good job! It looks pretty good as is
, I look forward to its next evolution! 
-
Nice mod pomsbz
Good to see some different tool configs - nicely done. -
Ingenious!

-
Had a thought of a variation of this mod. Basically a Pioneer X with the big/small blade from a 91mm. I prefer the thinner main blade which don't have the rather noticeable crinking of the Pioneers and I don't need an awl. How possible might that be? Would the blade spring work without something on its back to tension it? I also haven't a clue how to peen the pins on a alox model, how do you do it without wrecking the alox bumps on the handles?
-
Just finished sharpening it up, I don't care what happens, I'm not giving up centre line blades! It's such a joy to use! I've only been carrying single layer pocket knives for that reason. Once the blades move back to centre line it makes such a difference in how easy it is to hold and work with those blades. I'm revising my next version of this build. I'll leave the hook with the scissors and keep the awl on the back of the blades. I use the corkscrew for undoing knots and the awl works for that task if blunted. I'll do this sooner rather than later. I have all the parts including the spare liner and the extra collars I'll probably need by the time I've had the pins drilled out again on this knife. Only annoying thing is that the scales I ordered have the corkscrew slot. In any case it ain't over until the fat lady sings!

-
Glad you like the layout!

Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login
