Off brand challenge level 1
-
Sounds good! Will see what they have to say

-
I have seen these in the shops and was sometimes tempted, will follow to see how you get on with it
Stanley usually make ok stuff so i don't think you will struggle too much with it, hopefully they will sort you out for the broken bits 
-
Cool that someone is interested in my little challenge, and it is more of a challenge compared to carrying a Leatherman, Gerber or Sog. But it's fun to try something new that might be surprisingly good for the price

Sent fra min FRD-L09 via Tapatalk
-
I have looked at these for some time but I pocket carry and they look like they are too wide for that. Interested to see how you get along with them.

-
You could do a lot worse for the money.

I'll do the 30 day off-brand challenge one day...
-
I am looking forward to you opening a can with this!

Or at least trying... The opener looks a little too far to the right.
-
If I can find one that doesn't have the pulltab I might try, maybe it's more suited for left handed opening

Sent fra min FRD-L09 via Tapatalk
-
-
Beeing a lefty I would too

Sent fra min FRD-L09 via Tapatalk
-
Day 3:
Just a quick pic, been a busy day.
The wire cutters work very well, clean cut of the thickest and thinnest stranded copper wire I could find

Sent fra min FRD-L09 via Tapatalk
-
And the pliers don’t get stuck doing so :D
-
Now this is good to know, and since they're an integral part of the jaw should be plenty strong; no more exploding replaceable carbide cutters!!!


-
Not sure how much abuse they will take but for electrical wires they should be perfectly fine

Sent fra min FRD-L09 via Tapatalk
-
Day 4:
The flathead works well as a screwdriver and prybar


Sent fra min FRD-L09 via Tapatalk
-
That's good news, some of those drivers twist round into little corkscrews then snap off

-
These are more good news, and looks like it is pretty squared and even; most C&C's I've seen tend to be somewhat rounded at the corners and at the tip, making them useless as screwdrivers.
I'll be waiting/watching for the phillips driver test, and if any of the square driver adapters work on it; I have Leatherman's RBD, Gerber's Tool Kit, and a couple of generic ones, and hope that at least one works with the Fatmax!

-
Day 5:
Used the pliers to adjust a fuse holder to fit the cables. The pliers did a good job


Sent fra min FRD-L09 via Tapatalk
-
Good to know!

BTW, Is the handle splay uncomfortable? From the action picture, it reminds me of the factory Rev/Wingman/Sidekick splay...
-
@Juan el Boricua said:
Good to know!
BTW, Is the handle splay uncomfortable? From the action picture, it reminds me of the factory Rev/Wingman/Sidekick splay...
I've never really figured out what all of you mean by handle splay
Is it how far the handles open in use?Sent fra min FRD-L09 via Tapatalk
-
Double post
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login