Show off your Sak mod's!
-
@MadPlumbarian said:
I have a few parts one being a backside Philips and a saw and I think I’m getting a compact for Xmas, so simple and easy, or pop them all and go all out
JR
Sounds good to me, and I’ll give you a nudge if that’s what you’re looking for.
:) ;) -
No idea what I was playing at here but I like it! It works for me as a 2 layer but I feel with either a mag layer or a pliers layer (either or, not both) would make this even better!



-
@Helvetica Bold said:
No idea what I was playing at here but I like it! It works for me as a 2 layer but I feel with either a mag layer or a pliers layer (either or, not both) would make this even better!
Nice. I do something similar, but with the spring 1 liner width more under the saw. I did it that way because of the higher spring pressure in the saw tang. Liners ‘hide’ the exposed sweep of the tang. -
nice Good idea Helvetica Bold
is it the spring of the big blade?
-
@Helvetica Bold said:
Thanks Hulk. Yep same same spring as if it were a blade just need a thin .2mm extra spacer to take the wiggle out as the saw is thinner than the blade ;o)I thought you didn’t crink the saw!


….
84mm Stainless Metal saw. No bushing required at the pivot. Still in test fitting and needs final trimming, but geometry looks good so far.

-
84mm metal saw is quite a rare beast isn’t it? That’s down the small blade end isn’t it? Mine replaces the main blade which may be the difference?
-
@Helvetica Bold said:
84mm metal saw is quite a rare beast isn’t it?Original case hardened w/o the nail nick ones are. But I haven’t seen any of the Stainless or case hardened 91mm ones shortened to fit 84mm yet.
That’s down the small blade end isn’t it? Mine replaces the main blade which may be the difference?
Yes, it is. Sorry, I wasn’t posting it as an example of a main blade knife replacement.
-
1/2 Cadet X (2 layer, no openers, w/hook)

-
Great minimal edc combo…you can open beer bottles with the hook anyway ;0)
-
Thanks HB…I was thinking about making bit a ‘big money clip’. But I think that should be on a riveted knife. Well, unless the clip is crewed in too. I was thinking the 74mm clip pinned into the back scale.
-
Cadet X
Modern bits, vintage details.

-
-
Hi out there,
this may not be a very outstanding mod, but I wanted a clip at my Alox, and there you go.
Best regards from Germany

-
This one is a bit more sophisticated (prototype), with handle scales made of herdened steel. On one side, the scales are double layered and act as pliers.




-
Cool mod and pliers! Never seen that before, does they work as you wanted?
[It's not failure if you learn something from it]
-
Thank you very much! Yes, they work sort of fine. The pivot ocurs to be a bit weak, as after some use it started to wear out and now there's a bit play in it. Between the double layered scales (the pliers) I had added a detent-ball to secure the closed-position. This is a bit too strong, so you need quite some force to open the pliers. It is a prototype so I ought to create some advanced models.;o)
Best regards
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login

