Corkscrew or Philips Head
-
Have you guys seen this post? 42 uses for the corkscrew. /topic/40053
- Opens corked bottles (duh!)
- Untie knots.
- Pry the battery out of a cell phone.
- Screw it into a wall and hang your coat on the SAK.
- Staple remover.
- Smooth out the hole you just made with the reamer.
- Clear clogged faucet sprayer.
- Bicycle tire valve tool.
- Holds the micro screwdriver.
- Pick gravel out of tires.
- Rip open a blister package.
- Ice pick.
- Mark a pilot hole.
- Clean mud out of shoe soles.
- Knot the end of a cord. Thread it through the corkscrew. Handle.
- Pop balloons.
- Aides in sewing.
- Clean mud out of sprinkler heads.
- Push used snare wire through it, to straighten out the wire and remove coils or kinks.
- Pulls the drain plug out of a tub.
- Open the corkscrew and screw it tightly into a broomstick-thickness stick. Now open the blade. Tie it securely. Survival spear for fishing.
- Hang the SAK from a piece of cordage from the ceiling. Plumb bob (I have the middle of the handle marked on one mine).
- Corkscrew + a metal lid = a filter or wire mesh for cooking.
- Carry a chunk of C4.
- Pull frozen shoestrings tight, or help loosen them.
- Helps get the innards out of a squirrel.
- Gets the candle stub out of a candle holder.
- Start fights on multitool forums.
- Remove the fuel filter from a lawn mower.
- Although the new corkscrews are 4 turns, you can use them for range estimation.
- O-ring remover for your flashlights.
- Pry out partially-exposed nails.
- Tighten the apron strings on a wrestling ring.
- The inside diameter of the corkscrew is 1/4". I'm sure you know what you can do with this.
- Open just a small hole in a coconut.
- Lift stuck items out of boxes.
- Fish the tape out of a clogged VHS tape.
- Remove patches from a flintlock gun.
- Remove the inside of a shotgun shell, making a blank. Remove the wad and powder too.
- If you don't want the mini screwdriver, the corkscrew can hold a ferro rod.
- Tap a tree for sap.
- Undo zip ties without breaking them.
-
Truly, this is the answer
-
Philips is not the same as Phillips guys!
-
Nobody said the philips could be used as a weapon. I noticed the two openers could be opened, and the philips (or corkscrew for that matter) can be opened, and then the knife can be palmed, closing your hand around it to form a fist with the philips poking out between your fingers, and with those two openers pointing up and down out of the top and bottom of your fist they will make for some wicked jabbing and slashing weapons if you get crowded and don’t have room to swing. The knife handle itself makes a fist pack and the three opened tools add some hurt to the punch. This seems like it would make a heck of a bar fighting tool to get you to the door and out. Or maybe to have tucked in your hand inside a pocket as you cross the parking lot to your car at night, or walk home through a rough area. Corkscrew seems it would be too uncomfortable compared to the philips.
-
Despite the fact that I carry and use both, I voted corkscrew. I find it to be more versatile and get a lot of use out of it even though I’ve only used it on a bottle of wine once.
I like the Tinker family just fine, but the corkscrew wins out for me and I definitely carry corkscrew models more often. Especially since I also always have a Rambler too. Between that and the can opener, I’ve got most Phillips screws covered.
-
I actually prefer neither as I carry a Recruit or some version of Alox (Cadet, Pioneer X) but if forced to choose I would pick the corkscrew for the 42 plus uses and the fact that the Philips is mostly redundant, given the can opener works really well on Philips screws, and it is awkward to use in the T position. That being said the corkscrew is not something I really have a great need for and it does create a terrible hotspot on a knife.
However if they had a Compact with the Philips I would probably carry that over anything else.
-
@Steelej1976 said:
However if they had a Compact with the Philips I would probably carry that over anything else.I wish they just made a Compact with an awl instead of the hook. The tip of the awl is a perfect box opening tool for splitting tape and saving the blades from being gunked up. But honestly the Compact falls short for me in more areas than that. I’ll take a Climber Plus please, with a Compact hook swap out to gain the nail file.
-
Got to be the Phillips for me. I'm a Super Tinker fan. The t bar Phillips does have its uses. I have never found the small 'Phillips' on the opener to be useful as more often than not the screws I need to get to are recessed. The Phillips on the rear does a much better job in this regard.
I use the toothpick and my fingers for knots, never had any trouble and never found a corkscrew to be easier. The corkscrew is useful for storage and, for me, the tiny screwdriver that sits inside is useful - however I have modified a small bit to slot into my Super Tinker and it works great. I'd like to post about it on the forum just not sure where yet.
I carried a knock off knife for a while. Nowhere near Vicrorinox quality but served me well for years (still going actually!) And it had both a screwdriver and corkscrew on the rear so was easy for me to choose based on what I actually used.
-
WOW cannot believe I didn't vote
. In years past I preferred the phillips hands down. The problem with feeling that way was my most carried SAK was Explorer. I also was carrying a Swisschamp. I'm not sure why my thinking was not in line with what I carried
.I appreciated the phillips but my vote now aligns with what I have always carried.

Corkscrew.
-
Seems like it always happens that if I’m carrying a corkscrew SAK I run into recessed Phillips screws all day. And if I have a Tinker in my pocket I will find 17 things the corkscrew would be pretty helpful for.
:ahhh 
-
@RustandToil said:
The corkscrew is useful for storage and, for me, the tiny screwdriver that sits inside is useful - however I have modified a small bit to slot into my Super Tinker and it works great. I'd like to post about it on the forum just not sure where yet.I'd really like to see what you did, if you don't mind.
-
Perhaps this is the answer! ;0)
Both and with slightly less torque issues with the Phillips toward the middle too.
Still prefer the inline though!
Which, for me, means corkscrew on the back given the choice of only one.

-
@marlowe221 said:
Seems like it always happens that if I’m carrying a corkscrew SAK I run into recessed Phillips screws all day. And if I have a Tinker in my pocket I will find 17 things the corkscrew would be pretty helpful for.
:ahhh 

-
@Jazz said:
I'd really like to see what you did, if you don't mind.I've just posted a video here: https://youtu.be/M7nVKMzYzyM but once I get back at my laptop I'll add a thread in the Mods section with some photos. Very basic but I've found it really useful!
-
I prefer the look and feel of the Phillips, especially when whittling with the small blade. I’ve come around to appreciating the versatility of the corkscrew-mini driver combination, but I don’t prefer it over the Phillips driver, even in SAKs with an inline Phillips.
-
Wow nearly 2:1 in favour of the corkscrew - Woo Hoo - Usually I thought this vote was closer!!
How about the Explorer or the 111mm Outrider - Both still only four layers, but get Phillips and corkscrew
PS. I know this is not the OP Q!!I need to do a post on my theory that Vic is against the backspring Phillips
-
Backside Philips gets my vote.
-
CS my preference.

My Telluride build has both...but my preference has moved to a layer Phillips that I can use, and CS/awl back tools.
[attach id=0 msg=2391490]
-
I like Philips,,
JR
-
Hello. One of my favorite models has always been the Climber, but I admit that although it is not in the best position and the corkscrew has as many uses as you can imagine, in my day to day the Philips is more practical for me... but no That is why I stop using models with a corkscrew. I have time for everyone. Perhaps it is more emblematic is corkscrew. But since I really like the space race, the models used were from the Tinker range
Is it like having to choose who you love more, mom or dad?
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login
