Fixed Blade Challenge October
-
Day 28
Case Twin Finn set. When you're carrying the larger knife, these double stacked sets are great. You get a whole second knife (albeit a small one) with basically no space cost. On the other hand, most of them don't come with a solo sheath for the smaller knife, so you're stuck shelling out for extra. In this Case (hah!) the Mini Finn's sheath is an absolute monster compared to the knife itself. I've seen aftermarket kydex for it, but never picked one up. Maybe I'll try to take some scrap leather and make something for it myself.

-
Day 28
KA-BAR D2 Extreme
Another one I must admit to buying without plans to actually carry and use…

-
Day 27
Carried the Esse 4 today. Cut a 1 inch hose for a tractor PTO.

-
@Farmer X said:
That's good to know. My ferro rod striking technique is likely in need of improvement.Not all knife spines will work regardless of steel. It has to do with if it provides a squared sharp edge. Also, some ferro rods are easier to strike than others.
@nate j said:
Day 28KA-BAR D2 Extreme
Another one I must admit to buying without plans to actually carry and use…
Some knives just call to you. I’m sure it could come in handy in the zombie apocalypse
-
Day 28
I opened up a gift the wife received in the mail from a friend, although she said she wouldn’t try them until my mouth was healed enough to try them with her.
-
-
@Sos24 said:
Not all knife spines will work regardless of steel. It has to do with if it provides a squared sharp edge.The Izula II seems to have that squared-off spine. I think the coating on mine is proving to be a hinderance for effective ferro rod striking.
@AzteCypher said:
Based on what I found online it looks to be a G-Shock model GA-110TS-8A3.It sure is. And I'm just about certain to have a smurfload of cardboard to cut up tomorrow.
-
Day 27
I carried both of these today.
[attach id=0 msg=2549943]

-
@nate j said:
I would believe that. Have you tried with the Garberg?Yes. The Garberg, despite being stainless, is the best ferro rod striker I've yet found.
Day 29
Well, this wasn't the kind of use I anticipated. But I did cut a sheet of bubble wrap in half.
[attach id=0 msg=2550087]
My furniture has to wait till Monday, but the die-cast is a little safer.
[attach id=1 msg=2550087]
.jpg)
.jpg)
-
@Farmer X said:
The Izula II seems to have that squared-off spine. I think the coating on mine is proving to be a hinderance for effective ferro rod striking.The cerakote could be preventing a good strike
@nate j said:
I would believe that. Have you tried with the Garberg?The Garberg and Kansbol work well. I think Mora even specifies which of their knives have a good edge for striking because not all of them do.
-
Day 29
Buck has a great solution to the double sheath issues from yesterday. Their Paklite set can be carried as a double or as singles by removing one screw.


-
Day 28
Used the Becker 11 to open up a ZT 350 in Magnacut.


-
@Farmer X said:
Yes. The Garberg, despite being stainless, is the best ferro rod striker I've yet found.@Sos24 said:
Garberg and Kansbol work well. I think Mora even specifies which of their knives have a good edge for striking because not all of them do.Right. At one point, FX was blaming his ferro-rod striking technique. I knew the Garberg was a good striker and a knife that he owned. So, it seems like technique is fine.

-
Day 29
Bark River Bravo 1
This version features S35VN steel and Ghost Green Jade (natural; A+ for marketing) G10 slabs. With kydex sheath.

-
-
Day 29
Carried the Brisa Crafter again today. I used it to cut open a 40-pound box of cat litter but didn't take a picture.

-
Day 29
Cut some dog treats
-
@nate j said:
It seems like technique is fine.I hope so.
Day 30
For the final official day of the challenge, the thick and glossy piece of card stock met the Izula II. There was an action shot, but the phone camera smurfed it up (of course), so it wound up on the cutting-room floor.
This challenge went by pretty quickly. I won't be requesting the badge (as I doubled up on challenges this month), but I ain't done, either. I'll have final thoughts and a bonus photo for tomorrow.

Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login






