A "how-to" for basic SAK mods. Pic heavy.
-
You are very welcome mate.
I am just glad to hear folks are still getting some use out of it. :) -
Alright everyone. I think I am going to try my first real MOD. :ahhh I just need to find some part now.

I hope I have the actual tools need to do it as well.
-
Good luck.
And pics of your project are always welcome. :D -
I have been lagging on this big time. Hopefully it will happen sooner than later.
-
Ok, seriously thinking about modding my damaged Ranger...
But the bodyplate is of the old style... So, if I get a new small blade for it, I'm going to need the birds head spacer for it, AND the new main blade, AND the new body plate...
Is that right?
-
Thanks for the how to ! Makes it a lot easier to make the plunge into mods. Thanks again
-
You are very welcome.

-
Great thread. Thanks! What is the make/model of the drill press vise you are using? Thanks again.
-
Didn't this used to be stickied?
-
@ironraven said:
Didn't this used to be stickied?It's now linked from a single stickied thread along with a whole load of other modding guides; </topic/43303 the top of the Mod Squad page was just getting far too full of stickies. :)
-
I broke the stickies with my 58mm mod thread...

-
I have a few questions of an ULTIMATE rookie to modding and using tools.
1-What do you mean by "drilling out" the pins?
2-Will a Victorinox file work for "filing(I am not sure I know what it is)" -I mean the file on the metal saw.
-
@TurkTeen said:
I have a few questions of an ULTIMATE rookie to modding and using tools.1-What do you mean by "drilling out" the pins?
2-Will a Victorinox file work for "filing(I am not sure I know what it is)" -I mean the file on the metal saw.
-
Using a power drill with a 2.5mm bit to remove just enough metal to allow the bushing to come free.
-
Yes, a Victorinox file would work fine. "Filing" is just the act of using your file.
Hope that helps, if not just ask and I'll try and explain it better. :)
-
-
What diameter is the tiny pin?
-
Nice write up Gareth
-
-
-
Maybe one could add a small table with the pin stock diameters for the different models/pins.
-
93mm: 3.0mm, 2.5mm (center)
Also, 111mm. I'm not quite sure of those.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login
