Chevy Blazers
-
The 4.3L wasn't a replacement for the 2.8L model- it was the next step up. It was the big six, while the 2.8 and 3.2 were small sixes.
I can't find any information on the 3.2L. I've never heard of it in a Blazer. Here's the available engines I found for it for 1st generation models(1983-1994) as copied from Wikipedia. I wonder if maybe Canada had models and/or options that weren't available in the US. That would not surprise me at all. Even the state of California sometimes gets automakers to make specially tuned engines just for them.
First generation engines
* 1983-1984 - 2.0 L OHV I4, 2-barrel carbureted, 83 hp (62 kW)/108 ft·lbf (146 N·m) * 1983-1985 - 1.9 L Isuzu I4, 2-barrel carbureted, 84 hp (63 kW)/101 ft·lbf (137 N·m) (California) * 1983-1985 - 2.2 L diesel I4, 58 hp (43 kW)/93 ft·lbf (126 N·m) * 1983-1985 - 2.8 L LR2 V6, 2-barrel carbureted, 110 hp (82 kW)/148 ft·lbf (201 N·m) (VIN B) * 1985-1989 - 2.5 L Tech IV I4, TBI, 92 hp (69 kW)/132 ft·lbf (179 N·m) (VIN E) * 1986-1993 - 2.8 L LL1 V6, TBI, 125 hp (93 kW)/150 ft·lbf (203 N·m) (VIN R) * 1988 - 4.3 L Vortec 4300 V6, TBI, 150 hp (112 kW)/230 ft·lbf (312 N·m) (VIN Z) * 1989-1992 - 4.3 L Vortec 4300 V6, TBI, 160 hp (119 kW)/230 ft·lbf (312 N·m) (VIN Z) * 1990-1993 - 2.5 L Tech IV I4, TBI, 105 hp (78 kW)/135 ft·lbf (183 N·m) (VIN A) * 1992-1993 - 4.3 L Vortec 4300 V6, CPFI, 195 hp (145 kW)/260 ft·lbf (353 N·m) (VIN W/Z) * 1994 - 2.2 L L43 I4, MPFI, 118 hp (88 kW)/130 ft·lbf (176 N·m) (VIN 4) * 1994 - 4.3 L Vortec 4300 V6, CMFI, 195 hp (145 kW)/260 ft·lbf (353 N·m) (VIN W/Z)http://en.wikipedia.org/wiki/Chevrolet_S-10_Blazer#Second_generation
-
Either that or the 3.2L was just used in the Firebird/Camaro and other cars?
It might not have been put into the Blazer- I was just guessing since the 3.2 replaced the 2.8 in cars.
Def
-
Don't ask me. I've confused myself beyond all usefulness.
-
Nice pics Def! I'd be afraid to even drive those for fear of driving by a guy blowing sand out into the street or parking it under a tree full of birds :D
My "mods" would be utilitarian for the most part. I might even get a high end CB radio for it and ditch my Radio Shack one 8)
-
Dem Google guys gots lotsa purdy pitchers...


:D
Def
-
Another question; is the 4WD something you can *choose * to use when you need it, or is it 4WD all the time?
-
My 93 had an electric switch on the dash. Could run in 2wd, 4wd, or 4wd low
-
@Corrugated said:
Another question; is the 4WD something you can *choose * to use when you need it, or is it 4WD all the time?The older model Blazers (believe that's what you're considering) will offer 2WH, 4WH, and 4WL ranges. Those ranges are activated using a separate shift lever from the regular gear shift.
So you can choose 2WH for everday operation. Change to 4WH for slick conditions. Change to 4WL for really hard going.
However, there is a complication due to lockout hubs.
If your Blazer has lockout hubs (which are desirable for better gas milage and reduced wear on the front drive train) you'll have to get out and manually lock in the front wheels before you can use the 4WH or 4WL ranges.
.
-
it's narrowing down now...early 90's S10 4 door...automatic
Those won't have lockout hubs. They have a vacuum-operated front axle disconnect actuator.
-
The electric switch saves a lot of space over the actual transfer case lever but I prefer having the lever as you always know when you are in 4WD or not. I don't trust electrical switches... In this pic of a Jeep interior, the smaller, second shifter to the left of the transmission shifter is for the transfer case:

Try to find something with a lever with the markings "2WD, N, 4WD, 4LO" marked on it if you can.
Otherwise, you'll get a series of buttons on the dash like this:

There's nothing wrong with them, but like I said, I don't trust them myself. There's something to be said for pulling on a lever and feeling the gears mesh underneath you.
Def
-
@Defender said:
There's nothing wrong with them, but like I said, I don't trust them myself. There's something to be said for pulling on a lever and feeling the gears mesh underneath you.Def
Same here. Manual linkages for me. I trust cables and shifters long before and electric or vacuum motor. If you're not going to be spending much time offroad, don't worry about it.
-
Yeah, Terry is right- if you don't plan to get dirty, it's even less important.
However, when the snow flies, and the roads ice over, you may want that extra bit of confidence in knowing that it's on and working too. Terry doesn't know what Atlantic winters are like, so we'll forgive him for that! :P
Def
-
LOL. Very true.
I have an electric motor-operated transfer case in my 1995 Bronco, and I'm always sure to test it for proper operation before bad winter weather. The bad weather here in the southern Midwest is sparse, but that's actually what you have to worry about. The electric and vacuum motors will sit unused and seize up more easily.
-
The only time I'd put it into 4WD would be for snow and ice...The last winter here in RI many of the streets were not plowed correctly, or not plaowed AT ALL, and I fear this coming winter will be even worse. The state is screwed up from top to bottom; a 4" snowstorm and a 10-15 minute drive home turned into over 3 hours. There were kids stuck on school buses until midnight. That was with 4" of snow. So buttons on the dash woulden't be a serious problem for me. And what's a good way to test to see if you actually are using all 4 wheels?
Anyways enough of my babbling :D My father is talking me into geting a "newer" Blazer, year 2000 and up. His whole philosophy is "Get a car NEWER than the one you're getting rid of." Are the current crop of Blazers fairly easy to work on under the hood, or have they become another vehicle that you HAVE to take to a mechanic to do anything?
-
And what's a good way to test to see if you actually are using all 4 wheels?
Turn it upside down and see which wheels are still moving! :P
Your next step in dealing with bad weather is a set of these:
Def
-
And what's a good way to test to see if you actually are using all 4 wheels?
Turn it upside down and see which wheels are still moving! :P
Your next step in dealing with bad weather is a set of these:
Def
Those look awesome! Don't know how far I'd get without being pulled over by the police though...like I'd damage the already bombed out roads here ::) :D
-
Yeah, me too, but boy they look like fun, don't they? :D
Def
-
Terry doesn't know what Atlantic winters are like, so we'll forgive him for that!
Granted we don't get the snow like y'all do but we're just cold enough to get freezing rain which is pretty slippery too. Of course with ice it doesn't matter if you have front/rear/all wheel drive because NOTHING moves very good.
-
I bought a 1980 4wd K5 Blazer brand new and had several problems with it over the next 7 years. Since then, I bought Ford 4wd Broncos and F-250s and found them more reliable. YMMV.
-
Terry doesn't know what Atlantic winters are like, so we'll forgive him for that!
Granted we don't get the snow like y'all do but we're just cold enough to get freezing rain which is pretty slippery too. Of course with ice it doesn't matter if you have front/rear/all wheel drive because NOTHING moves very good.
Yup- we get that here too. Next time we have a good one I'll take pictures- imagine absolutely everything outside covered in 1/4" of slick, wet ice, and that's what we get. And I mean everything- cars, roads, houses... you name it, all with a nice, thick layer of ice over them!
Def
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login



