58mm Mod Question
-
Pretty sure the clip is secured by pins that are further apart on their centers. A ruler will tell you for sure.
Edit: even if the pins are the correct spacing, wouldn't the clip be too large on the 58mm frame? -
58mm pins are 1.5mm, while 74mm are 2mm, so there's that to contend with too.
-
Forgot about the diameter difference, but, perhaps the peening could be generous enough to capture the clip.
-
The pins spacing is not the same. About 7 mm on 58 mm and about 10 mm on 74 mm.
-
Not going to make that up with peening. Thanks for the answers!
-
You could get oversized pin stock then sand down a section to the right size for the 58mm, leaving the correct size for the clip.
-
beat brass into the holes and redrill for 1/16
-
Check this out: </post/895266>
-
@jrp316 said:
Check this out: http://forum.multitool.or....msg895266.html#msg895266Hey, I was just looking for that :P
-
Thanks!!!! jrp316. I WILL check that out!
I really like the idea of using the knife as a dangler.Will
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login