Chevy Blazers
-
Avoid anything with the 2.8L engine- they were some of the worst engines Chevy ever fielded, and were replaced with the much better 3.2L engine in '87 if I'm not mistaken..
You may have just had a typo but it was the 4.3L that replaced it. Although I've known a few people who had the 2.8L and never had any problems. It wasn't anything special but it wasn't too bad either. But yeah, if you can get the 4.3L. That engine is essentially the famous Chevy 350 with 2 cylinders cut off. It's bulletproof.
-
@ducktapehero said:
Are you wanting the full size K-5 Blazer http://en.wikipedia.org/wiki/Chevrolet_K5_Blazer#1973-1991 or the smaller one S10 Blazer http://en.wikipedia.org/wiki/Chevrolet_S-10_BlazerHmm, I'm kind of confused with all the info I've been reading, but I'd like the smaller one with 4 doors.
Thanks for the links, and thanks for the info Def...it's narrowing down now...early 90's S10 4 door...automatic :D
And is the Jimmy the same as an S10?

-
And is the Jimmy the same as an S10?
Pretty much, yeah.
-
it's just the GMC version ;)
-
The GMC Jimmy and Chevy Blazer are the same truck, just with different badges.
The 4.3L wasn't a replacement for the 2.8L model- it was the next step up. It was the big six, while the 2.8 and 3.2 were small sixes. My experience with the 2.8 and 3.2 are from my old Firebird, but I remember it was hard to get parts because the Jimmy/Blazer guys were hogging them all! Other than the sheet metal and lack of a transfer case, the Firebird/Camaro was almost identical to the S10/Blazer/Jimmy underneath.
The S10 was a pickup variant, but as the smaller Blazers were built on that frame, they were referred to as the S10 Blazer. The GMC Version of the S10 Pickup was called the Sonoma.
S10:

S10 Blazer:

I agree with DTH- the 4.3L is a great engine. The smaller six (3.2L) will need to work harder to give the same results, so you aren't saving any fuel running the smaller engine, and you are increasing wear. The 4.3L also delivers a fair bit of power, and there's all kinds of aftermarket goodies to make it run faster, better and more efficient.
The automatic will be a column shift rather than a floor shifter, which may or may not affect you much- personally I never managed to get used to a column, but I drove one for a year and managed well enough.
One other little thing you may want to look for specifically- some models have a rear windshield wiper and some don't. Get one with the wiper, otherwise you'll never see a darn thing out the back.
The post '95 models were redesigned and somewhat more rounded/streamlined, and can also be had at a good price. If possible, you should try to get something a little newer rather than older, just because it's probably got less on it needing repairs. You can probably find a decent 95-98 Blazer for around $3k if you look long enough. Unless of course you prefer the older body style, in which case, a man's gotta do what a man's gotta do! :D
1995 Blazer:

Def
-
kudos on the GM knowledge boss :D
-
Thanks- my family has always had trucks, and while we've never really had any specific loyalty to one particular brand, we've had more GM's (and GM owned brands) than any other. My folks had a '74 Jimmy that we had right up until '90 when the floors rotted out of it, and I've always had a soft spot for the Jimmy/Blazer line as a result.
My own car buying career has also been dominated by GM, although I really have no particular loyalties either (but that's quickly changing with the new Jeep! :D). My first car was the afore mentioned Pontiac Firebird, then a VX Fox, then a GMC Tracker (Suzuki made, but branded GM), then a Pontiac Catalina (sister car to the Parisienne), then a Pontiac Sunfire, and the Jeep. I was considering a number of truck brands when I looked at the Jeep, but avoided Blazers and Jimmys simply because my father in law has a Jimmy and I wanted something different... plus I am having a mid life crisis and I needed a convertible! :P
Def
-
@Defender said:
The automatic will be a column shift rather than a floor shifter, which may or may not affect you much- personally I never managed to get used to a column, but I drove one for a year and managed well enough.Def, did some model Blazers have a 3-speed manual shift on the column? Seem to remember driving one like that, but I may have it confused in my mind with an older Ford Bronco.
I never owned a Bronco or a Blazer, but did drive ones belonging to friends a fair amount.
The manual column shift on the Bronco was really awkward - I got used to it, but always hated it.
.
-
I'm not entirely certain- it's possible, but I've personally never seen one. I have seen some Fords with three on the tree, so I'd lean towards the Bronco for that one. Still, it's likely that Chevy had one as well.
Def
-
Chevy Trucks are all I personally have ever owned my wife had a Ford Probe when we first got married but now shes got a truck as well :D
-
@Poncho65 said:
Chevy Trucks are all I personally have ever owned my wife had a Ford Probe when we first got married but now shes got a truck as well :DSo I guess it's safe to assume Chevy trucks are pretty reliable :D
Open question to anyone...do the two door Jimmys/Blazers have a backseat also or is there just a backseat on the 4 door versions?
-
I have had 2 Blazers. The first I got when I was 17. It was a 1972 with a 350 4 speed. That truck took a lot of abuse and kept on going. :D
The second blazer was a 93 4 door with the 4.3. Good ride and would get about 20mpg highway. Had to replace a fuel pump and had problems with the anti lock brakes. I got rid of it because I wanted to go back to a pickup.
I also had a 2002 S10 pickup with the 4.3. I had it about 4 years and put 60,000 miles on it. Only problem was had to replace front brake pads. Sold it last summer. Nice truck. -
The two door models do have back seats.
Def
-
@Defender said:
I'm not entirely certain- it's possible, but I've personally never seen one. I have seen some Fords with three on the tree, so I'd lean towards the Bronco for that one. Still, it's likely that Chevy had one as well.Def
Manual column shift was standard in 1966 - 1977, but was not offered after that. 1978-1996 had h-pattern floor shift.
The early ones are easy to convert to floor with a Hurst shifter kit. I have one in my '67, and would never consider going back to the column shift.
-
Wow, lots of Chevy owners/fans here :o
Both cars I've owned had shifting on the column and that's what I'm comfortable with. My moms car has the shifter on the floor and I've got no problem driving it after about 10 minutes, same with the trucks at work...so where the shifter is isn't going to be a problem.
Def, Are the two door models any shorter than the four door models? It's hard to visualize without actually seeing them in person...this whole week I'm going to keep my eyes peeled while I'm out for Blazers :D
Another open question; How easy is it to mod these Chevys? Like If I wanted to put a spotlight on one or a new stereo system...would I run into any weird problems?
-
@Corrugated said:
So I guess it's safe to assume Chevy trucks are pretty reliable :DAmerican car manufacturers have had trouble competing with European and Japanese companies in the car department sometimes(although recently our cars are just about as good as anyone else's) but you gotta give us credit when it comes to our trucks. Ford, Chevy(GMC) and Dodge are all good trucks.
-
I'm not certain if they are any shorter or not- I don't think so, but if they are, it's not by much.
The Blazers and other GM trucks are indeed reliable, but don't think that means never fixing it. You'll replace ball joints about every other year at least, and probably have to replace the brakes every year, but then that's usual truck stuff.
When it comes to modding, the sky is the limit on Blazers. Do a search for "Blazer mods" or "custom Blazers" or get more specific and search for "light kit chevy blazer" and you'll see that they are ripe for upgrades and modifications. Also, pick up a few issues of "Mini Truckin'" Magazine to see even more cool custom stuff like these:





Good luck! :D
Def
-
The 4.3L wasn't a replacement for the 2.8L model- it was the next step up. It was the big six, while the 2.8 and 3.2 were small sixes.
I can't find any information on the 3.2L. I've never heard of it in a Blazer. Here's the available engines I found for it for 1st generation models(1983-1994) as copied from Wikipedia. I wonder if maybe Canada had models and/or options that weren't available in the US. That would not surprise me at all. Even the state of California sometimes gets automakers to make specially tuned engines just for them.
First generation engines
* 1983-1984 - 2.0 L OHV I4, 2-barrel carbureted, 83 hp (62 kW)/108 ft·lbf (146 N·m) * 1983-1985 - 1.9 L Isuzu I4, 2-barrel carbureted, 84 hp (63 kW)/101 ft·lbf (137 N·m) (California) * 1983-1985 - 2.2 L diesel I4, 58 hp (43 kW)/93 ft·lbf (126 N·m) * 1983-1985 - 2.8 L LR2 V6, 2-barrel carbureted, 110 hp (82 kW)/148 ft·lbf (201 N·m) (VIN B) * 1985-1989 - 2.5 L Tech IV I4, TBI, 92 hp (69 kW)/132 ft·lbf (179 N·m) (VIN E) * 1986-1993 - 2.8 L LL1 V6, TBI, 125 hp (93 kW)/150 ft·lbf (203 N·m) (VIN R) * 1988 - 4.3 L Vortec 4300 V6, TBI, 150 hp (112 kW)/230 ft·lbf (312 N·m) (VIN Z) * 1989-1992 - 4.3 L Vortec 4300 V6, TBI, 160 hp (119 kW)/230 ft·lbf (312 N·m) (VIN Z) * 1990-1993 - 2.5 L Tech IV I4, TBI, 105 hp (78 kW)/135 ft·lbf (183 N·m) (VIN A) * 1992-1993 - 4.3 L Vortec 4300 V6, CPFI, 195 hp (145 kW)/260 ft·lbf (353 N·m) (VIN W/Z) * 1994 - 2.2 L L43 I4, MPFI, 118 hp (88 kW)/130 ft·lbf (176 N·m) (VIN 4) * 1994 - 4.3 L Vortec 4300 V6, CMFI, 195 hp (145 kW)/260 ft·lbf (353 N·m) (VIN W/Z)http://en.wikipedia.org/wiki/Chevrolet_S-10_Blazer#Second_generation
-
Either that or the 3.2L was just used in the Firebird/Camaro and other cars?
It might not have been put into the Blazer- I was just guessing since the 3.2 replaced the 2.8 in cars.
Def
-
Don't ask me. I've confused myself beyond all usefulness.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login



